2002 Toyota Camry Solara - Page 7 - Answered Questions & Fixed issues
Need to replace a cable
Welcome to FixYa.com
I searched the FixYa data base and we do not have the
Diagram or step by step that you need. However, I found a site which you can go
to get the information you need. Go to www.automotiverepaironline.net
They have one for you, Lee
1/31/2011 5:14:22 PM •
Toyota Camry...
•
Answered
on Jan 31, 2011
•
37 views
I am noticing my radiator
there are relay switches for your fan and it could fautly or so and maybe changing them out will help, but before that it could be a engine overheating issue too such as low coolant level. With low coolant level, it could your engine is running a little hotter then normal and when you turn your engine off, the fan comes on to help cool your car down. So at least check your coolant level or try to fill up, if it still comes on after that, then it prombraly a bad relay fuse.
1/22/2011 5:12:54 AM •
Toyota Camry...
•
Answered
on Jan 22, 2011
•
92 views
HOW DO I RE ATTACH
The wire that has 12 volts to it goes to the center terminal of the lighter/power outlet, the ground wire goes to the outside sheet metal retainer ring..
1/21/2011 9:47:09 PM •
Toyota Camry...
•
Answered
on Jan 21, 2011
•
93 views
My car has engine light
- In the vast majority of cases, simply cleaning the MAF sensor does the trick. Consult your service manual for it's location if you need help. I find it's best to take it off and spray it with electronics cleaner or brake cleaner. Make sure you are careful not to damage the MAF sensor, and make sure it's dry before reinstalling
- Inspect all vacuum and PCV hoses, replace if necessary
- Check for a dirty fuel filter and proper fuel pressure
- In the vast majority of cases, simply cleaning the MAF sensor does the trick. Consult your service manual for it's location if you need help. I find it's best to take it off and spray it with electronics cleaner or brake cleaner. Make sure you are careful not to damage the MAF sensor, and make sure it's dry before reinstalling
- Inspect all vacuum and PCV hoses, replace if necessary
- Check for a dirty fuel filter and proper fuel pressure
- good luck.
1/21/2011 2:29:44 AM •
Toyota Camry...
•
Answered
on Jan 21, 2011
•
143 views
How hard is it to
Seat belts are pretty simple. The airbags just be careful the one in the steering wheel is pretty easy but the one on the passengers side can be a pain.
1/13/2011 6:23:05 AM •
Toyota Camry...
•
Answered
on Jan 13, 2011
•
99 views
It does not start or
If the engine turns over easily , check the timing belt. Let me know what happened when the car died and We might figure it out, Also the year, make, model, engine size
11/26/2010 3:22:29 PM •
Toyota Camry...
•
Answered
on Nov 26, 2010
•
58 views
Where can i get a
you will need to get a Japanese (english) manual.OR find a manual for the equivalent (different name)car (whats a "coaster" ,not available in Europe/Russia.........
10/22/2010 10:41:20 AM •
Toyota Camry...
•
Answered
on Oct 22, 2010
•
1,129 views
Wanting to remove backseat bottom
Put your fingres between seat and body and pull upwards. Harder, thats it, see its out. To put it back use the palm of you hand once the lugs are centred.
10/2/2010 2:06:56 PM •
Toyota Camry...
•
Answered
on Oct 02, 2010
•
66 views
Car runs then dies toyota
Problem may be idle control. In throttle body, butterfly valve can get gummed up and stick causing motor to start but then die. Remove air passageway from front of throttle body and spray intake cleaner or chemtool B12 inside while holding throttle open. This should clean up gummy residue and allow idle control to work properly. This works for us.
1/10/2010 2:14:13 PM •
Toyota Camry...
•
Answered
on Jan 10, 2010
•
247 views
I have a 2001 Toyota
Happens all the time on ours. You need to take two flat blade screwdrivers and work out the fold in the
seal belt at the top and push the belt back into the slot and all will be well. It takes a few minutes of
working with it and perhaps a few choice words but
if you will keep at it and undo the fold in the belt, it will go back in. To avoid this in the future try to get in the habit of holding the buckle straight out in front of you as the belt retracts when you unfasten your seatbelt.
1/10/2010 2:09:36 PM •
Toyota Camry...
•
Answered
on Jan 10, 2010
•
371 views
What cause a car make the noise on the wheels when driving.
1- It could be wheel bearing worn down. You can check this by jack up each wheel, and juggling in rotation to see a circular gap play.
2- It could be wheel nuts loosed to make noise. Remember after replacing tires, any shop always tells you to bring car back after driving for a certain distance to make sure these nuts are not loosing.
11/15/2009 5:22:00 AM •
Toyota Camry...
•
Answered
on Nov 15, 2009
•
160 views
Need settings and sequencefor toyota 4y engine the big end and main bearings as well as top
no car told year, make or model the books on engines are by that. only
wiki said this.
OHV eight-valve
Displacement: 2.2 L (2,237 cc)
Bore and stroke: 91 mm × 86 mm (3.58 in × 3.39 in)
This engine was available either carburetted (4Y) or fuel injected (4Y-E, called the GW491Q/LJ491Q and also 4G22B for Chinese manufacture). As fitted to a 1989 Daihatsu Delta truck, the carburetted 4Y produces 70 kW (95 PS; 94 hp) at 4400 rpm (SAE net)[5] and 18.6 kg?m (182 N?m; 135 lbf?ft) at 3000 rpm.[6]
Applications
1987.09 - 1995.12 Toyota Crown (YS132, overseas specifications)
Toyota Van (Town Ace overseas specification, Tarago in Australia)
Hiace third generation (overseas specification)
1979-1988 Toyota Stout (YK110)[citation needed]
Daihatsu Delta
1993-1995 Daihatsu Rocky F95
Toyota Industries forklifts
Toyota 4Runner (Australia)
Volkswagen Taro
1985-1997 Toyota Hilux fourth and fifth generation
sorry nobody can guess the car or the country . nor the VIN.
Not finding what you are looking for?