2002 Toyota Avalon - Answered Questions & Fixed issues
2002 Toyota Avalon Car Radio Wire Diagram
2002 Toyota Avalon wiring diagram, my friend cut the harness thinking he knew what he was doing so now I'm trying to replace the harness but do not know the right diagram colors
5/6/2021 8:12:53 PM •
2002 Toyota...
•
Answered
on May 06, 2021
•
1,983 views
How do I replace the alternator belt on a 2002 avalon
I have included an image for reference. There is a tensioner included in the pulleys the belt travels around. (Red X). There is also a spring loaded lever point you use to release the tension on the belt.
Remove the covers to expose the belt. **Take a photo or draw the route the belt takes so you don't forget when putting the new one back on.**
Facing the belt and using a ring spanner or swan neck spanner, turn the adjuster clockwise, (green circle). **NOTE** There will be a lot of tension on the spring so take your time as it could slip and snap back into place, taking at least one knuckle with it. I always find a helper at this point makes the whole thing A LOT easier.
Once the adjuster is swung over the belt should slide off one of the pulleys and then off completely. Gently ease the adjuster back to it's rest position.
Replace as follows. Using your reference image and your helper, swing the adjuster clockwise as far as you can. Position the belt, making sure it is squarely positioned on each pulley. GENTLY ease the adjuster back off and recheck it is squarely set on all the pulleys.
At this point you can start the vehicle to check the belt in running correctly then after turning the engine OFF refit any covers over the belt.
7/5/2018 1:46:05 PM •
2002 Toyota...
•
Answered
on Jul 05, 2018
•
752 views
Which O2 sensor is needed for The code P1135 tOYOTA aVALON 2002
code p 0035 refers to heated oxygen sensor(HO2S)--LH front ---heater circuit malfunction===causes ---wiring--HO2S--air induction system---fuel pressure ----injector/s---ECM
heated oxygen sensors are always located in the exhaust manifold/pipe before the cat converter
they control the fuel/air ratio parameters for the ECM to get best burn of the mixture
Oxygen sensor (O2) is always after the cat converter and sets the parameters for the cat burn off
12/10/2016 2:42:27 AM •
2002 Toyota...
•
Answered
on Dec 10, 2016
•
332 views
Why the air bag light came on?
some thing is wrong with air bag system, computer pick up a code.have them pull codes to see what going on where s the problem,
9/27/2016 4:15:21 PM •
2002 Toyota...
•
Answered
on Sep 27, 2016
•
57 views
I recieved the following Warning lights: VSC and Engine Check
You have an issue with the engine. The other lights come on when the Check Engine light comes on. The most common reason for the Ck Engine light on is a loose gas cap. If the cap is tight, you will need to find someone who can scan the car's ECU and give you the DTC code. Without the code, we cannot provide any more ionfor at this time.Get the code and get back to us; then we can solve the problem.
9/14/2016 10:44:20 PM •
2002 Toyota...
•
Answered
on Sep 14, 2016
•
1,544 views
Car won't start 2002 toyata ipsum nothing works apart from lights in side and head light's dash doesn't light up either ?? Any ideas
Start with the basics: Do you have all your fluids at normal levels? Does the engine turn over when you turn the key? Check the voltage on the car battery -- it should be between 12.8 - 14V without load, any lower and your battery may be too flat to start the car. That check engine light means the onboard computer does know something's up. Go get an OBD2 scanner and plug it in, read the code, and work from there.
If your engine is turning over, then the fuel isn't igniting for whatever reason. Check your battery, check your plugs, and check your fuel pump to make sure the engine is getting fuel.
8/4/2015 7:11:34 PM •
2002 Toyota...
•
Answered
on Aug 04, 2015
•
274 views
Not finding what you are looking for?