20 Most Recent
2000 Toyota Tundra Questions & Answers
My 2000 tundra has what seems like a vacuum leak i
you can spray around the engine with CRC or Wd 40or the like when its still fairly cool(for 100% safety)especially around the inlet area and it probably may start to run smoother ...you just need to look where its getting sucked in through the leak(temporarly sealing it)1 or so seconds maybe a little more and thats your answer unles a vacuum hose is off or split you havent spotted
I have a 2000 Toyota Tundra with the 4.7 engine. I
the code reader would have identified which bank it pertained to so have the code read again
if the same shop say differently , take it to another place and have it read for free then comment with the code reported
you can then go on line to autodata web page and have the code identified
2000 tundra v8
Some time when you got new sensor s they have to be coded so the cry recognise them and some after market items aren't as good so try and get an oe part.
I need to replace starter
No you do not need to remove the plenums. The starter is removed and installed from underneath the truck of from within the wheel well if the wheel is removed. You should go buy a Haynes or Chilton repair manual for $20 they are indisposable to do it yourselfers and will give detailed step-by-step instructions with pictures.
Engine dies when put in drive
Have you checked to see if you have any codes in the engine control module ? Even if the light is not on, it will store codes which are not a major problem.
Have you done any routine maintenance to your car lately, like a tune up ? Have you checked your air filter ?
Not finding what you are looking for?
