20 Most Recent
2000 Toyota Tacoma PreRunner - Page 5 Questions & Answers
Time string toyota tacoma 2000
Time string? Do you mean the timing belt? 100-140 miles is a good rule of thumb. Definitely have a pro do it though, things can get tricky on a truck that new.
Code P0171 system to lean
Hello. Welcome ot FixYa. Please allow me to assist you.
The P-0171 code indicates, in most instances of this code being set, a dirty Mass Air Flow sensor.
This sensor is located in the pipe between the air filter box and the throttle body.
What I would do: Locate the sensor, remove the wiring connector, remove the sensor, and, with some commercially available "Brake cleaner" (a spray can), spray the interior of the sensor until it is clean. Do not use compressed air, as the pressure can and will damage the sensor. After the sensor is cleaned by spraying the brake cleaner in it, reinstall the sensor, hook up the wire connector and drive the vehicle. The computer will see the sensor reading the correct amount of air flow, and the light should go out.
Thanks for choosing FixYa for assistance today.
I own a 2000 toyota
In the front, place your jack stands on the stabilizer bar bracket that is bolted to the frame...
in the rear, put the jack stands on the rear end, closes to the outside as you can get...
Hope this helps ??
Have 2000 toyota prerunner. have
Replace the entire switch, not just the tumblers. Before installing the new switch take it to a locksmith along with your old switch key and have the new lock keyed to work with your old key. This will save you from having a different key for the doors & switch.
2000 toyota sr5 v6, 3400 four cam 24 engine. I was
Best guess is its a fuel delivery issue. I would check the fuel pressure to make sure it is within the range it is suppose to be. It could also be on the return side. A bad fuel pressure regulator could cause the system to have low fuel pressure. Before pulling the pump or anything get under it and pitch off the return line to the tank. The pressure test the system again. It should almost double like from 60 to 100 lbs of pressure. Those are gm numbers so dont look for those exact numbers. If it does not have the increase like i mentioned then the regulator is bad.
Check engine light stays on
This means the computer has detected a problem with your vehicle. Take it to Autozone and they scan it for free for you. They will let you know what is wrong and what you need. Thanks for choosing FixYa.
Not finding what you are looking for?