20 Most Recent 1999 Toyota Camry Solara - Page 3 Questions & Answers

sounds like one of your blend doors are faulty, the cable is out of place or broken, or the cable has stretched

even with a fast right foot? stalls right, it starts ok, runs ok but stalls, right?>

rear struts and swaybar bushings are usually the problem

if heat is good, and fan blows. does it, that be first. then the dampers are failing easy huh ,but why is the question. ill answer for ever car, too lazy for me to do look up below link. on cable system the bad connections on electric damper motor bad or controls. and Vacuum servos stuck or controls to it bad. you can log in and look any time. its all there, under HVAC. every failure and steps to do each tests. on dampers. http://www.scantool.net/software/alldata-diy-1-month-subscription.html

ok, you never said how you know that>? 1: pressure zero 2: crack fitting dribble tests? 3: cant hear it ( i cant either cranking,) some cars about 1/2 only run the jump cranking and running. not just key on. (FSM is the only book that answers this tricky question) some cars have ECU flash updates that change this rule. so read the TSB on that.. why not post the symptoms so pros can answer.....????? 1: cranks ok 2: no start. 3: spark is good and compression all good, on all cylinders if compression is low on all , the timing belt fell off, and BOOM ! 4: spark good, you try test fuel. a: runs for 3 seconds, suspect no injection. b: dont run, at all bad that, check compression at WOT on all cyl. suspect bad injection; A: check pressure cranking, (no key on, but cranking) i get 30psi, its good. i get 5 psi or 0 , bad pump or now 12vdc to pump cranking. B: pump at 30pis cranking so i run a NOID lamp test on all injectors, it fails... (ask for how to go past here...... longer story.... more complex than you though , huh?

Have you tried cam or crank position sensors? These will cause issues like these as well.

short or bad ground bad connection

nono... go in through the engine. Pop the hood and you can do it without detaching anything but the old fog lamp.

Hi Rick,There is a number of problems,1. You need to give the car a proper service. Change plugs, filters, brakes, all the oils. 2. clean the valve body with the flow sensorsThe black smoke is most properly from the engine oil that is combusting. This will stop as soon as you have change the air filter.3. make sure that the spark plug wires are in a good condition as well.

this is a traction control fault indicator light. this is most commonly caused by a faulty wheel speed sensor. you'll want to bring the car into the shop to be hooked up to a computer for a proper diagnosis.

Will it latch if you push the release handle down, you know opposite of trying to get it to release? It might be a broken or dislodged retaining spring that pulls downward pressure on the release handle. If this is not the problem then the teeth on the gear that the release handle engage are possibly worn out.

maybe its the board holding the fuses faulty