1998 Toyota Sienna - Answered Questions & Fixed issues
1998 Toyota Sienna. The left rear cylinder, no fluid when bleeding brakes.
Question edited for clarity, full 'year make model' and no abbreviations please 'cyc' for 'cylinder, spelling 'braks, 'bleding'.
Question moved to model category.
It has ABS, you need a pressurized bleed system that puts the brake fluid in at the wheel slave cylinder end pushes it up to the master cylinder reservoir.
Or
You use a bi-directional Scan Tool Computer to open the ABS Valves.
12/6/2023 7:12:17 PM •
1998 Toyota...
•
Answered
on Dec 06, 2023
•
30 views
98 SIENNA FIRING ORDER
98 Toyota sienna has 3.0L V6 has a coil pack w/two electrode ground plug for each cylinder.
5/29/2021 10:40:39 PM •
1998 Toyota...
•
Answered
on May 29, 2021
•
849 views
After driving over a speedbump or pothole, I will
Could be your shock absorbers , push down on both sides of the back wing , so push down and let go to see if both sides go up and down the same amount of times . Is one side more bouncy than the other Break light switch on the break peddle might need adjusting so check that , or use a multimeter on your back light good luck colin
7/9/2017 7:54:31 PM •
1998 Toyota...
•
Answered
on Jul 09, 2017
•
96 views
I have a 1998 toyota sienna van.about 4 months ago
low on fuel has two serious consequences
the fuel pump runs dry and destroys the plastic gears and
all the rubbish in the tank is sucked into the pump and filters and to the injectors
at this point , use a quality injector cleaner and see what happens as a misfiring injector is more likely blockage in the injector
4/29/2017 1:07:11 AM •
1998 Toyota...
•
Answered
on Apr 29, 2017
•
163 views
The interior light on the doors of the car will not turn off. how do i turn them off? happens when the car is off.
most cases one of 2 things you turned the dash lights on to the point where the lights stay on.....or there are small switches that opens and makes contact to turn the lights on when the doors are open when you shut the door the contact is released and it turns the lights off. Some the times the wire can come disconnected and leaves an open switch and the doors thank that they are open therefore the light stays on it should have only one screw to hold it in place, you can gently pull this out and find out if the wire is no longer connected. Or if the door plunger gets broken off the door cannot turn the switch off because it is broken.
3/5/2016 3:20:03 AM •
1998 Toyota...
•
Answered
on Mar 05, 2016
•
129 views
Not finding what you are looking for?