20 Most Recent 1995 Toyota Camry - Page 5 Questions & Answers

Probably not. I'd suggest that you check the rubber seal. Sometimes you have to remove, clean, and re-install them with rubber cement. Tracking down and fixing the leak is a lot more rewarding than drilling holes to let the water run out. Cheers.

probably find a plug in a hole under the spare tire

That means trouble with the manifold pressure sensor, which causes trouble with injection and ignition timing. See here p372http://www.turboninjas.com/camry/eg1.pdf

Should be set screw at throtlle.

Search Results

5SFE Engine Idle Adjustment Screw - YouTube

? 2:16 www.youtube.com/watch?v=C7a0ejq5be8 May 2, 2012 - Uploaded by Special EDy Here is the location and operation of both the Idle AdjustmentScrew and the throttle opener. ... Is it the same 2000 toyota camry 5sfe? Read more Show less. Reply · 1 ... Now you gotta readjust the tps to the new idle speed.

What engine is in it.

knock sensors on v engines are on the insides of the cylinders in the v the wires and harness will run down the v of the engine

run the fault codes and check for problem injectors

It will not

It is possible that there is no coolant on the engine side of the thermostat. Sometimes there is an air lock that will not let the coolant reach the thermostat on the engine side. It may open from the coolant heat if the engine is run long enough, but you have to watch the engine temperature, or you might overheat it.

replace the relay fuse then. If the relay is stuck closed its no good if it should be reading temps to open current.

1995 Toyota Camry wiring diagram Google Search

There is two mounting ears with 10 mm heads on them and there is a rubber plug on the bottom pull up after ttwp bolt are removed

Hello pry on it with a plastic pry bar it schhould pop off

Please try and go to autozonne and. See if they can get any engine code from obd2 please reply best place to start

The resister puts current to the motor when you change speeds on switch so if you motor only work in one or two speeds you no the resister is bad if you put current direct to motor make sure. It runs if ok change resister thank you and please reply

with the power switched off probe the wiring harness with a ohms meter to body earth, any cable that reads zero other then a earth cable has a short.

The timing marks to use are spot-drilled on the faces of the timing gears.
The timing marks on the camshaft gears must align side-by-side, and as closest as possible on the Toyota,Camry 2.2 engine.

If the engine temp exceeds the limit the computer can kill the ac. If the cooling fan stops working the engine temp can go up and also stop the ac from being cold.Do you know if the cooling fan is working when the problems happen ?

That is for a faulty knock sensor, a simple repair