Top 10 1994 Toyota Corolla Questions & Answers

16331a code is for thermostat

loosen the bolt that is holding the adjuster of the alternator. loosen the belt by pulling it and the alternator would slide in. remove and replace the belt.

do the reverse on installation.

remember to tighten all bolts of the adjuster and alternator after tightening the belt.

tnx 4 using fixya,

drcool

Yes, there is illumination behind the heater control panel.

You need to remove the center inst cluster upper (radio) & lower finish (heater) panels to gain access to the heater control; the light socket is behind the heater panel.

You will have a leak from the pump, pressure hoses or the rack. You will have to get the system washed down and inspected for the leak, most common problem is the steering rack leaking, this will leak oil onto the exhaust and cause your smoking problem, start her.


Remove the power steering pump pulley.
Place a drain pan under the vehicle. Important: Cap or plug the ends of the power steering hoses to prevent fluid loss.
Disconnect the power brake booster inlet hose from the power brake booster.



Disconnect the power steering cooler hose from the power steering pump.



Disconnect the power steering pump remote reservoir hose from the power steering pump.



Raise and support the vehicle. Refer to Vehicle Lifting.
Remove the power steering pump rear mounting bracket nut.
Lower the vehicle.
Loosen the accessory bracket bolts and nut. Pull the accessory bracket forward.
Remove the power steering pump mounting bolts.
Remove the power steering pump and the power brake booster inlet hose from the vehicle.
Remove the power brake booster inlet hose from the power steering pump.

you can use 10w 30 or 5w 30. 5 is going to be better for cold locations and is the more universal of the two and 10 is going to be good as long as you don't go much below freezing.

The following is from a Haynes manual for 1993-1996 toyota corolla and geo prism:

Code 14: ignition signal. No ignition signal to the ECM. Check igniter or circuit, ignition coil, ig. switch or circuit, ECM (engine control module or "computer")

Code 24: intake air temperature sensor. Open or short in the intake air temperature sensor circuit. Check intake air temp. sensor or wiring to ECM.

tienes que poner el cylindro numero 1 a TDC. en el cyclo de compresion del cylindro. pon el dedo en el abujero de la bujia y que le de vuelta alguien al motor, y cuando sientas que sale aire, entonces estas en el cyclo de compresion, despues ponle un desarmador largo al cylyndro y cuando le des vuelta al motor fijate que llegue el desarmador a la posicion mas alta antes de que se vuelva a bajar y entonces estas en TDC. Ya cuando estas en TDC, ponle la cadena de tiempo al carro y listo.

The fuel pump relay is located in the fuse box drivers side of fuse box

try checkin your dashboard wiring or checkin yor fuses.

Hi, there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything
someone on fixya recommended it to me

They have full manuals and it's verrrrry cheap and mine
I got free in offers
3rd time I bought it, I also had an issue with the file so the girl replaced it in 30 mins
There is another one one bitmanual, also great content
Or try youtube?