20 Most Recent 1991 Toyota Previa - Page 9 Questions & Answers


Sounds like a possible vacuum leak, check to make sure all hose are connected and serviceable. Make sure your intake hoses/pipes are secured and fastened from the filter on to the throttle body. Also you can use a screwdriver to slowly turn the idle adjuster screw at the throttle body. This will Raise the idle of your vehicle. However only if all else fails.

1991 Toyota... | Answered on Dec 14, 2009


You are asking me to pay for a solution, but if I have solved it, you ask that I give you the solution?

1991 Toyota... | Answered on Dec 08, 2009


Removal & Installation
  1. Disconnect the negative battery cable from the battery.
  2. Raise and safely support the vehicle.
  3. If equipped with 4WD, remove the front drive shaft.
  4. Remove the nut and disconnect the starter wire.
  5. Disconnect the starter connector.
  6. Remove the bolt holding the starter stay to the upper stiffener plate.
  7. If equipped with 2WD, remove the starter by removing the nut and three bolts.
  8. If equipped with 4WD, remove the starter by removing the nut, four bolts, and the center bracket.
To install:
  1. If equipped with 4WD, install the starter, the center support bracket, nut, and the four bolts.
  2. If equipped with 2WD, install the starter, nut and three bolts.
  3. Install the bolt to hold the starter stay to the upper stiffener plate. Tighten the bolt to 43 inch lbs. (5 Nm).
  4. Install the starter connector.
  5. Connect the starter wire with the nut. Tighten the nut to 78 inch lbs. (9 Nm).
  6. If equipped with 4WD, install the front drive shaft.
  7. Connect the negative battery cable.
Good luck and this should take about 2 1/5 hours from start to finish and if you like, use lock tight medium strength to make sure the bolts don't go lose on you.

1991 Toyota... | Answered on Nov 04, 2009


You need to check a couple of things. If your car has been sitting, then it could be any of a number of problems. Check to make sure that you have the three things your car needs to run. 1. Air- is the air filter clean with no blockages like mouse nests on the intake side and also in the exhaust pipe!! 2. Fuel- Do you hear the fuel pump kick on for 2 seconds when you first turn the ignition to the run positon? If not, your fuel pump could be suspect. 3. Spark- If you have air and fuel, but no spark, then your ignition system is under investigation. Be methodical you need all 3 of these things for the car to run, without any one them your stuck!
Hope this helps you out!! Try running the car on propane, if it runs beautifully, then you know it's a fuel delivery problem.

1991 Toyota... | Answered on Oct 08, 2009


You should have two "wires" going to the starter. One (bigger cable) will have positive voltage all of the time. The other (smaller) will have positive voltage only while the key is turned to "start." If you have both of these, your starter is bad.

1991 Toyota... | Answered on Oct 05, 2009


Did you try to Jump start it?
If you did and wouldn't start I would Check your starter.

1991 Toyota... | Answered on Sep 25, 2009


It'in your Rack&pinion check your power fluid level to make sure it's
full to. this can be tested very easily,

1991 Toyota... | Answered on Sep 25, 2009


check for battery voltage , if good, it's your starter

1991 Toyota... | Answered on Sep 25, 2009


they have many problems with the sockets and bulbs.. take bulb out look at bottom of bulb see if the two terminals are melted together.. also check good for ground to socket.... bad grounds and sockets get to hot i wouls recheck good... also if you see a little black module on light housing that will be the lamp out module... to let you know you have a lightg out.. if you have that option.... try replacing

1991 Toyota... | Answered on Sep 01, 2009


It is probably a oil pressure problem. If there is some sort of small blockage in an oil journal it could stop oil from flowing to the lifters which would cause the the tapping noise. at this point the best thing to do would be to try and flush out the engine with some sort of desludging agent. One thing i usualy do is drain the oil and re-fill it with atf and run it for about half an hour or an hour and then re-drain and replace with normal engine oil. transmission fluid contains tonnes of detergents and should help clean out any blockages.

1991 Toyota... | Answered on Aug 31, 2009


you will need an electric fan fitted to the radiator and bear in mind that you will need the appropriate voltage reading etc,so you need the right power source.Also you need to consider a thermostat fitted in the cooling system unless you want to run it on direct power.For any questions,please ask.

1991 Toyota... | Answered on Aug 25, 2009


Hi, check the fuse box under the dash on the passenger or driver side. There is a cigarette lighter fuse that may have burned out. if the fuse is in good condition, this will confirm element failure. you will need to replace the lighter head in this case(uncommon).

**Most common issue here will eb a busted or burned out fuse..

1991 Toyota... | Answered on Aug 18, 2009


i would replace the brake switch it is located on a small bracket attached to the brake pedal ounder the dash

1991 Toyota... | Answered on Aug 14, 2009


check your c/v joints on the ends of the front drive axles. a split or torn boot indicates that the joint inside has become contaminated with road dirt and has failed.

1991 Toyota... | Answered on Aug 02, 2009


my 1991 LUCIDA will not let any air into the front cabin via the outlets I suspect the diverter flap is closed but do not know how to get into it can you help

1991 Toyota... | Answered on Jul 16, 2009


Probably cooked the ecm. Very bad for cars to do this...

1991 Toyota... | Answered on Jul 13, 2009


well if they say they did not do its a hard thing to fight all you have to do is bleed the brakes and that does not cost anywhere near 2000 try a small garage

1991 Toyota... | Answered on Jul 09, 2009


Turn Signal/Marker Light REMOVAL & INSTALLATION
  1. Remove the one retaining screw from the upper corner of the lens.
  2. Tape the end of a pry tool, then carefully extract from the bottom of the lens in a rocking motion till the stud is loosened from the retainer.
  3. NOTE: Do not pry from the back of the lens, this will crack the lens or damage the paint.
  4. Pull the lens assembly straight out from the body towards the front of the vehicle.
  5. Twist and remove the wiring from the back of the lens.
  6. Twist the bulb and remove it from the socket.
Fig. 5: Once the bulb is removed, inspect the socket for corrosion 90916p10.jpg
To install:
  • Before installing a light bulb into the socket, ensure that all electrical contact surfaces are free of corrosion or dirt. NOTE: Before installing the light bulb, note the positions of the two retaining pins on the bulb. They will likely be at different heights on the bulb, to ensure that the bulb is installed correctly. If, when installing the bulb, it does not turn easily, do not force it. Remove the bulb and rotate it 180 degrees from its former position, then reinsert it into the bulb socket.
  • Insert the light bulb into the socket and, while depressing the bulb, twist it 1/8 turn clockwise until the two pins on the light bulb are properly engaged in the socket.
  • To ensure that the replacement bulb functions properly, activate the applicable switch to illuminate the bulb which was just replaced. If the replacement light bulb does not illuminate, either it too is faulty or there is a problem in the bulb circuit or switch. Correct if necessary.
  • Install the socket and bulb assembly into the rear of the lens housing; otherwise, install the lens over the bulb.
  • Insert and secure the lens assembly into the body of the vehicle.
  • 1991 Toyota... | Answered on Jun 25, 2009

    Not finding what you are looking for?
    1991 Toyota Previa Logo

    316 questions posted

    Ask a Question

    Usually answered in minutes!

    Popular Products

    1992 Toyota Previa
    1992 Toyota Previa

    231 Questions

    1993 Toyota Previa
    1993 Toyota Previa

    -106 Questions

    1995 Toyota Previa
    1995 Toyota Previa

    191 Questions

    1994 Toyota Previa
    1994 Toyota Previa

    151 Questions

    1997 Toyota Previa
    1997 Toyota Previa

    -55 Questions

    Top Toyota Experts

    Marvin
    Marvin

    Level 3 Expert

    85206 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22484 Answers

    Jonah Oneal

    Level 3 Expert

    14092 Answers

    Are you a Toyota Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    View Most Popular

    Previa Toyota

    • Previa Toyota

    Most Popular Question

    oil pump toyota previa not lubricating

    • Cars & Trucks
    Loading...