20 Most Recent 2006 Toyota Sequoia - Page 6 Questions & Answers

You need to take out the broken piece and you will be left with a rectangle hole to insert a tool. I took a screw driver and bent the last inch over just past 90 degrees. I then inserted the bent end in and felt the latch mechanism (it is horizontal). Put the tip of the bent screwdriver on the lever and then pull down. Make sure the hatch is unlocked. You can pry open the space between the glass and the rubber and look down with a flashlight if you have trouble feeling the latch. There is also a good video on You Tube. Type in Sequoia rear latch handle and you should find it. It is about 10 min long and show you how to take off the inside panels to replace the broken part

it is lable cig.radio.accessory.there should be a fuse bx under hood and in the car under dash glove box it will be inside the car fuse box.

Sorry, the process is simple but too lengthy to post here.

Goto homelink.com

They make the system and have very complete instructions you can download.

PLEASE NOTE: MOST but not ALL Brands / models of opener will work with this system.

GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: MOST BUT NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS

GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS

thermostat stuck open poss

The cabin air filter is located behind the glove box, inside of the blower housing.

This is most likley a fuse or a relay.

set the mileage when the odometer is showing. put the key to off position. press and hold the reset button then turn the key to on position, do not start. then continue holding the reset button until the reading stops to zero or blank. turn it off, that should reset the light indicator

Try napa auto parts,take the shock with you to match it up.

a hard click, each time u try to start until the conatcts on the starter meet then it spins. Starter bad , but if u know how to take the cover off the solenoid u can see the replaceable contacts (usually just one side worn) and u could purchase at a starter rebuild shop and fix it for under $12.00

Turn the key to run, just before the start position. Then youre able to move the shift lever.

Emissions control unit. It controls emissions by adjusting engine settings.

See explanation of what it does here:
http://www.tundrasolutions.com/forums/engine-and-drivetrain/54203-how-exactly-does-the-ecu-work/