20 Most Recent 2006 Toyota Sequoia Questions & Answers

1. Traction Control System Problems - Car Forums and Automotive Chat ...

   www.automotiveforums.com > ... > Toyota > SequoiaTraction Control System Problems Sequoia Car Forums. ... The VSC/ATRAC indicator lights are staying on and the system will inadvertantly ..... giving a bad reading following the replacement of the steering angle sensor with a new one.

You're going to have to look into the console, it sounds as if it has a broken solenoid rod or it's disconnected. The fact that you can hear it click verifies the system is electrically sound. I hope this helps. Take care.

The VSC TRAC and TRAC OFF lights come on everytime the CHECK ENGINE light comes on. I think you just need to get the light reset.

Brian
Toyota Certified Body Shop Estimator

Tap on wiper motor while it is turned on and see if it moves . Also check the connection at the motor for loose connection and for corrosion . Unplug it and plug it back until it clicks to lock .

No fuel shut off on that car and if it was the car wouldn't run at all sounds more like an idle control valve not working. Scan the car or have it scanned and it should tell you if it's bad.

Yes. Security systems generally only prevent the engine e from starting/running. They do not affect any other systems. Theft system light should be on or flashing if theft system is problem

it could be fuse or wiring issue

Possible transfer case problem. is the transfer case full of lube? check that first.

here is a video,hope it helps https://www.youtube.com/watch?v=ht2GD4GvJ_c

a misfire will cause this to happen go get it scanned to be sure.

That won't burn out the compressor. It could be dead already. There are several things that will keep the light on, in the dash. High, low pressure switches, A/C .heater controller malfunction, wiring, and the compressor is bad. All these turn the light on, but all will shut down the system. Put it on a scanner and find out what's wrong.

Sounds like this is normal. It is warming up the motor. If it's more than 1500RPM after you start it up, you might want to have it checked. It should idle around 500 to 800RPM

This procedure is also listed in the owner manual for future reference: Step 1: with the key in the on position, push the trip reset button until the odometer is displayed. Step 2: turn the key to the off position Step 3: push and hold the reset button and turn the key to the on position Step 4: hold the reset button until the odometer is once again displayed This light is programmed to come on every 4500 - 5000 miles

Fig. 4.7L engine Firing order: 1-8-4-3-6-5-7-2 Distributorless ignition system (one coil per cylinder) This was at autozone ,com Good luck, Miike