2004 Toyota Avalon - Page 9 - Answered Questions & Fixed issues
Washer fluid not spraying
Does the motor make a noise like its trying to pump when you press the water button? Best way to check is when the car is off and you turn the key to accessories, then try the water. If you hear a humming noise, your fuse and motor are working and you have a blocked spray unit. Just use a pin to unblock it. If you dont hear a humming noise, locate the fuse and see if it is faulty. If the fuse is fine, your motor is bad so replace it. Hope this helps
How replace bearing
from your description the do it your self fix is another motor from the wreckers. If it is a big end there will be crank shaft journal damage and that means major rebuild and lots of dollars
A replacement engine will be cheaper and less costly in the long run.
Missing fire
a bad injector can cause a miss, you can listen to each injector with a stethoscope. It should make a rapid clicking sound. If it makes a deep thumping sound it is likely bad. also an intake leak can cause a miss at idle. also an EGR valve partially open can cause miss at idle. I always check cylinder compression when replacing plugs or coils for a miss. You need quality tech to check for above items.
2006 toyota avalon blowing white smoke in the morning
This sounds like coolant is leaking into the combustion chamber so when it is cool remove the radiator cap and see if the coolant level is low which will indicate that the engine is consuming coolant. Pressure testing the cooling system would be the next test to check for such a lek.
What is engine code 407
Well if the code is P0407 its not any type of failure.
Code 407 means there may be a problem with the EGR valve or the wiring for the valve. The valve and wiring would need to be checked.
The EGR valve is part of the emissions system.
Po155
You did not specify year of vehicle but if you did it right you have replace B2 S1 wish is located on exhaust manifold, by radiator B1S1 is on exhaust manifold by fire wall. good luck
No check engine lights
If there's none when you first turn the switch on,then the bulb is burned ot and needs replaced.
Not finding what you are looking for?