20 Most Recent 2004 Toyota Avalon - Page 3 Questions & Answers

The cabin filter will be located in the a/c- heater plenum which is behind the glove compartment, remove glovecompartment.if you have access to a lublic library they have mitors msnuals that will give instruction for replacement.

1 Tools needed are a Phillips screwdriver and a socket wrench. Open door to passenger side of vehicle. 2 Under the glove compartment is a kick plate cover held in place by four screws. Remove the screws and take off cover. 3 The door to the cabin filter is now visible. Remove screw in door and unhinge. 4 Remove the first filter by pulling straight down. Remove the second filter by sliding forward and pulling down. Replace with clean cabin filters. Reattach door and kick plate cover.
Good luck and hope this helps. 

I have a 2004 Toyota Avalon. When I put the headlights in the "ON" position; I can barely see the dash lights! Is this a problem with a fuse, the lights behind the dash or the dimmer switch

If the belts are good the noise could just be the a/c compressor making noise. The compressor is the only thing that is not normally spinning until the a/c is activated and the a/c is activated by the defrost to dry the air. Cheapest thing to test is the belt I would replace the belt and if it is not the belt you can try the compressor. If it is the compressor then you have a extra belt to put on later.

call a real mechanic!!!! could be any number of things!!!!

Fuel Pressure at Motor?Spark while Cranking?

The panel where the fuse is on the driver side of the vehicle where your left knee would be under the dash, take off the panel and look at the diagram it will should say acces. I believe it is a 10 amp and you should have an extra in the main fuse box under the hood

don't you have the owners manual? you can check your manual, and you will find where oil filter is.------auto diagnostic scanner JBT-CS538C

The warning lights are telling the driver there is a problem with engine performance which affects the other two systems.You need to have the engine and body computers scanned for trouble codes to proceed.

could be your battery or your starter

Why doesn't anyone check for codes, whenany light comes on the dash?Check for codes,diagnose codes related issuesYou need a repair shop,you have Vehicle Stability ControlFaultsShould tell you in the owners manual