Top 20 2000 Toyota ECHO Questions & Answers

you can get guide from many sites.. i know few error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered within seconds u can get the access and it's totally illustrative complete

Possible faulty injector low cylinder compression or intake manifold vacuum leak

Time to go see a transmission specialist.

Just a guess but it might be your fuel relay fuse check out the fuse panel on the outside fender wall drivers side and there's one inside the car drivers side there's a little panel that comes off to get at it hope this helps

Then the battery is defective.

are you getting a check engine light if so read the codes and see what it tells you them cars had a lot of problems with the box located under the rear of the car back from the tank just check out that system

a repair manual will probably tell you. it has maintenance schedules, models of commonly replaced parts (spark plugs, oil type, weight etc) http://www.papertownspdf.com/downloads/toyota-yaris-echo-repair-manual-1999-2010/

Possible fuel problems. Dirty fuel filter or injectors....this can also be an ignition problem. If any codes showing up have them checked at any Autozone for free

Here is the wiring schematic for the rear lights. The wiring colors are included

TOYOTA YARIS VERSO ECHO VERSO SERVICE REPAIR MANUAL 1999 2000 2001 DOWNLOAD My problem was easily solved. I hope your too :))

you have a faulty sensor call your dealer and ask the some time the answer those question with no charge $$ !

Replacing fuel pressure regulator on Toyota Vitz, Yaris and Eco: 1. Remove rear seat. 2. Remove rear service hole cover. 3. Remove fuel pump and vapor pressure connector. 4. Start the engine till it stops on it own and switch the ignition to OFF. 5. Remove the tube joint clip, wrap a piece of cloth around it and pull out the main tube. 6. Pinch the fuel emission tube connector clip and pull it out. 7. Remove the 8 bolts and fuel tank vent tube set plate. 8. Remove the fuel pump assembly. 9. Remove the O ring from fuel pump assembly. 10. With help of screw driver remove the fuel pump locking plate. 11. Remove the fuel pump regulator with screw driver a bit force fully. 12. Assemble the fuel pump assembly in the reverse sequence of dis assembly. Hope that it works. Thank you for visiting Fixya.

Sounds like a transmission problem, and a dangerous one. You should take it to a good transmission specialist as soon as possible. Automatic or manual?

Sounds like an engine misfire.Does the check engine light come on or flash. If so, it may be a spark plug or ignition coil issue. The transmission can also cause a shudder problem. These transmissions are usually rather dependable though.

On the display go to settings or tools and see there if this option is available.

is your engine 1sz-fe or 1nz-fe or 2nz-fe

The unit with the fan in it comes out separate you shouldn't have to remove the radiator

same

If you go to the gates belt site and put in the info on the car, it will show you or you can use the autozone website if you make a free account and put in the car information.

Check the fuse first, then see if you can turn fan by hand to see if it's froze...probably need a new fan