Top 20
1997 Toyota Camry - Page 7 Questions & Answers
Dashboard warning lights
There is a switch on the transmission that tells the indicator what gear it's in. It sounds like that switch has gone bad. The indicator lights might be due to the computer picking up a fault with the switch. You should take it in somewhere and get it scanned. You could go to an auto parts store for a free scan but they will probably try to sell you every single part that might cause that code, taking it to a shop and paying them a little money to confirm what part is bad is worth the money in the end. If you need further help, reach me via phone at
https://www.6ya.com/expert/forrest_f5a3e9d21691ce99
Car wont start after replaceing batterty
The most common cause of a non-starting car is the battery. It is either weak, (low voltage) dead, (zero voltage) or has bad connections. (corroded or loose) I will assume you have a fully charged battery with good connections. (both to battery and starter relay) Just becaue its new, don't mean its good or fully charged.
If you remove the starter switch lead (small wire) from the starter relay and apply +12v from the battery to its respective prong or lead on the relay, and your starter cranks, your starter switch is faulty. (not to be confused with your key switch). If you jump the two large wires together on the relay and it cranks, then the relay is faulty. If you jump the two large wires together and nothing happens, then starter is faulty, or wires to starter are loose or broken. Picture of starter switch prong on the relay is pictured. NOTE: sparks are to be expected, so don't be too scared.
Cold radiator
Check the coolant for anti-freeze.
Air pocket in coolant can cause over-heat.
Put car in oil change ramp and SLOWLY fill the tank to MAX level.
Check for leak(s)
Rear tie rod adjustment sleeve/pulls to right/1997 toyota
are they incompetent?
the dont makes excuses, they do, or order parts.
find a real ASE mech. yours, is noob.
had it looked at , is the uncle fester or what?
wreck?
my guess, is cant wrench turn the tie rod adjustments do to rust.
buy a new rod, or use a torch and heat cycle it, all mech now what to do , Pen oil, then heat then buy new one.
1997 camry ce 1mz v6
Almost certainly it is coming from the rear bank cam cover gasket, for which leak the Camry V6 is notorious. Other common places are the distributor shaft o-ring seal, the crankshaft nose seal (replaceable), and the oil filter adapter bracket (if fitted)If you get the cam cover gaskets done, specify Toyota parts, as the aftermarket parts don't last, they harden quickly.
Backup lights out bulbs ok
its just 2 parts , not counting wires, fuse or dead battery.
car runs? Head lights work? at same time?
the switch is bad.
or the bulbs are bad.
the A/T car (auto not stick)
the PRNDL prindle switch does this.
did you try wiggle the lever in REV. with person 2 behind you watching.
did the lamps flash,? bingo bad PRNDL.
with a Volt meter, any (1920 to now) you check the voltage
at the PRNDL, , 12v in , and
0v out , in reverse is bad switch.
1-10v out is a short in the line, (less that 11volts is a short)
12v out is good, your lamps are bad, unplugged . or cut.
top hard fail here is some hack job (uhaul infamous) cut the wires all
up and used wire nuts (illegal on cars) an fails hard.
2009 camry LE dashboard console lid stuck how to
Depending on where you are located, I would either take the vehicle by your local Toyota Dealer or locate (through your online search engine) a specialized foreign/domestic auto repair shop and ask a service advisor if they can take a look at it and pre-determine (prior to spending money) if they have had problems in the past with them? Then I would inquire if they could kindly assist you in repairing the issue. More than likely something is jamming the release from opening, or it is internally broke and will need to be replaced.
97 diagram fuse
its in the operators guide ,get one, never drive with out,
getting stranded is a bummer.
Not finding what you are looking for?