20 Most Recent
1990 Toyota Xtracab Questions & Answers
3vze timing belt kit
the vin number has specific build identifiers that may help. run the vin on google or call your dealer. also the part your looking for i just purchased on ebay for half of what my parts guy wanted. let me know if this helps..
Drivers side front hub makes a low grinding noise
If the grinding noice lasts for just a few seconds, don't worry about it. If it grinds along time or constantly, the hub is not disengaging fully then you need to take it to a mechanic for sure. Good Luck.
I have a 1990 corolla
Good Evening, since you have replaced the usual toyota subjects which are the computer and the distributor (normal causes), the next possibility is the crankshaft position sensor. We got one of these a while back and the local new car dealer where it was traded in at said it was the fuel pump, replaced the usual suspects, then ended up ohming out the crankshaft position sensor and it was bad. I hope this helps, and if you have any more questions please feel free to ask.
Thanks,
Joey
1990 toyota pickup 22re 4 cyl. no spark.replaced
1. Verify the coil and igniter do not lose power during cranking as if the ignition switch were bad.
2. Verify the igniter is getting a good ground through its mounting. If all test good a faulty replacement part may have been installed.
The ground wire that runs from the negative battery terminal to the fender gets corroded or broken see if thats the problem.
1. Verify good battery voltage to both sides of the ignition coil.
2. Scope the coil negative to see if it is getting pulled all the way to ground by the igniter.
3. Can also check for about 5 degrees dwell on coil negative while cranking.
The Engine Control Module (ECM) . does not create spark on this vehicle. The ECM can only change ignition timing. It cannot cause a no spark condition. hope i helped!!!!!!!!!!!!!
1987 Toyota Pickup 4x4 Problems
I
hello, it sounds like the alternator is the problem, most auto parts stores can check the alternator/charging system at no charge without removing it from the truck, I'm sure you will find that the alternator needs to be replaced.
How to bleed the air
You have to take the filter of and then fill it up with fuel then replace filter without spilling any fuel out to cause more air to get in the line. When you try to crank the car or truck over it may take a few trys but it should start after a few trys.
Not finding what you are looking for?