20 Most Recent 1990 Toyota Camry - Page 5 Questions & Answers

I would replace the lock cylinder in your car, that will take care of some of your issues that you are having. Next check your wiring to the safety neutral safety switch and your transmission linkage for play both at the trans and at the shifter, your car still doesn't know what gear it is in and until it knows it will never let you start it. I hope this helps I’m happy to assist further over the phone at https://www.6ya.com/expert/brock_d67526d2a834c47e

check the dimmer switch for the dash lights..also check fuses ..good luck

REPLACE BUSTED FUSES

Check for broken air intake hose; vacuum leak. Also check coolant level.

There should be screws you can remove in the bottom of your console to remove it

I would next look at the coolant temperature sensor, on which the car's computer depends for a signal to tell it when the engine is too hot. There might also be a suspicion that combustion gases are getting into the coolant, via a leaky head gasket. There is a test for that the mechanic can do.

check your ignition control module or coil

If you mean the fan for the heater/air conditioner (HVAC), first, check the fuse.

make sure you have all the timming marks up when putting the belt on

if you hve a chalk my your markings in the firing order at 1 then remove it to replace it with a new belt.

There is no starter relay on the 1990 camry 4cyl . If you check the fuse panel by the drivers left ankle you will see that there is a socket for a relay but it is missing. On the manual transmission cars it has a relay in that socket. The black and white wire goes directly through the neutral safety switch to the ignition switch.You can see that same wire on the plug in connection of the starter. If you are having intermittent cranking it is probably high resistance in that circuit, If you are handy just install a relay before the starter connection and have the black and white wire just power your relay coil. The new relay must then be connected to the battery plus and the out put to the plug in wire you cut to install the new relay.

do you haveck engine light onn