20 Most Recent 1986 Toyota MR2 Questions & Answers

Bolts are the most commonly used parts in automobiles, because all automobile mechanical parts require bolts. We often see the words 4.8\8.8\12.9 on car bolts. In fact, these are the marks of bolt strength grades. The strength grades of bolts refer to the performance grades of bolts used in steel structure connections. Commonly they are grades 4.8, 8.8, 10.9, and there are more than 10 levels including 12.9 level in toyota calya.

Don't worry I'm sure you will get the solution of your problem, just check the link I attached Toyota MR2 1983 1998 Workshop Service repair manual

their were 3 engines for the gen 1 mr2 a 1.5 --1.6---1.6 supercharged Toyota MR2 Wikipedia the free encyclopedia

burning coolant most likely blown head gasket

the capacitor for the pump is bad its a can strapped to side of unit inside it youll put your eye out working on it . only 35.00 to buy one.

The pump is in the fuel tank. To test short pin 1+2 on the air flow meter connector. Turn the ignition key to run position (2 click) and listen for the whir or hum of the pump.

If the U-joint is worn out on part # 45260, then that whole part needs to be replaced. There are no serviceable items on that piece. In order to remove it, you'll need to remove the retaining bolts part# 90119-08560 (top and bottom of said shaft), then you may have to pry the collars apart to get them to release from the other piece of the shaft. To make it easier, disconnect the lower portion of the steering shaft from the gearbox/rack and pinion. Also note, the shafts may be D shaped so shaft components may only be installed one way. If they're not, you'll need to mark positions on the remaining shaft components to when you're installing the new part the orientation stays correct. It also may be beneficial to lock the steering wheel in a set position so it doesn't rotate otherwise your turn signal cams may be in the wrong orientation and may not work properly. i.e. may not lock when depressed, or turn off at the wrong steering wheel position.

Try MHHAUTO.com they the best.

its in the FSM. or at alldata.com , log in and read. like us. or at mitchels.

Check thermostat,waterpump

COULD BE A BAD CONECTION @ BATTERY ,OR STARTER COULD BE GOING OUT,

It depends on what you need overhauled and what is wrong with it. Check on Swedespeed or turbobricks, or any of the Volvo lists - there may be a Volvo guru near your location who is trusted and has decent prices. In Colorado, there's Carl Duke Volvo in Loveland and in Denver you have Voltek - both are excellent independent shops with people who love Volvos and know them inside and out. And not just the new stuff.

You can checkout some Troubleshooting questions here, otherwise our technical staff are always available to answer your questions