20 Most Recent 2007 Toyota Yaris - Page 3 Questions & Answers

The contacts in the light dimmer assembly module are burnt or have poor contacts. - Take the keys out. Remove the negative battery terminal and wait 90 seconds. - Remove the steering wheel (Note: Place the steering pad in upright position since it has airbag in it) in the center position and remove the light module. - Remove the module lid and you will find 3 or 4 brass contacts in it. - Clean and rub the contacts with #400 abrasive paper and install it back. Good Luck.

Try to check the forums for any Recalls on this vehicle, if there is, you should receive a letter with the problem that you mentioned, simply take the letter, and they will take care of it for free. if you don't receive anything, then take it to your Car insurance and they can either fix it for you, or point you in the right direction. hope this helps!

have the battery load tested have the belt condition checked and adjusted

check and replace the fuel filter inside the fuel tank

I would start with the fuel filter.

where is the noise coming from

You don't need a dealer for much of anythingAll of todays vehicles require removing the lampassembly or housings,front or rear, of any vehicle,totake out the lamps/bulbsIf you open the hood you will find screws that hold it in placeMay not be an easy job, but that's the junk were sold

You need a wiring diagram of the fuel circuit, here is a link to a possible source of the diagrams. http://bbbind.com/free_tsb.html One note you understand the pump only runs when the engine is being cranked?

2007 Toyota Yaris RELAY ASSEMBLY CRUISE CONTROL AUTO DRIVE Part 9008498032

Anticlockwise

here you go an on line page with all your specs just write down the ones you need. off save page for off line viewing. http://www.allwidewallpapers.com/2007-toyota-yaris-engine-specifications/MjAwNy10b3lvdGEteWFyaXMtZW5naW5lLXNwZWNpZmljYXRpb25z

Try one of the pay for information sites because it is not published for free that I can find.

Water in connection. Unplug and use some electrobe lube or Vaseline on the connections.

Pull up the error codes after which you would be able to repair the defect.