20 Most Recent
2007 Toyota Camry - Page 9 Questions & Answers
Trunk will not close
check that latch is releasing when using remote. remote uses a cable to pull latch and cable may need to be lubed causing the latch to stick open. Let me guess if you slam a couple times it will latch, lube the actuator cable and latch well. hope this helps
Can't get my wheel off, despite having lug nuts off and jacked up
At this point, the only thing that I can recommend it to get a piece of wood, a 2 by 4 is best. Place the wood on the inside of the rim (to protect the aluminum rim), and whack the board with a larger hammer until the wheel dislodges from the hub. Spin the wheel and whack the board. Repeat. We do this quite a bit on the really stubbborn rims. Hope this helps.
Won't accelerate, jerks and loud clanking noise
My new 2007 Camry V6 did the dance you describe at about 2000 miles. It turned out to be a bad transmission, the so-called "snap ring" problem. They replaced the transmission under warrantee. However the new one did the same thing at 1800 miles on that transmission. I sold the car back to Toyota and bought a Hybrid. You need a Toyota dealer to look at it. Good luck!
PO 441
This is a incorrect purge flow code, try replacing the purge vsv located on the hose that has the green valve cap on it, one hose has vacuum when the engine is running the other hose goes back to the fuel tank, the valve has an electrical connector on it .
Not finding what you are looking for?