20 Most Recent 2003 Toyota 4Runner - Page 9 Questions & Answers

If the wiper motor when bad, and stop in any position ,other than its resting position, the rear body ecu disable the window motor, Do this test remove the rear panel and at the same time that the wiper switch is On ,tap the motor with the hammer gently if it gets activated the problem is the motor. If you need further help, I’m available over the phone at https://www.6ya.com/expert/flavio_517b938f50183b92

When you question group size, cca, etc. I assume you are talking about battery, even though your query doesn't say as much.

Go to any major chain auto parts store (Pep Boys, Advance, Auto Zone, O'Reillys, etc.) to get this info.

Here is a good start, good luck and please rate me good!
http://www.toyotanation.com/forum/forumdisplay.php?f=266

TRY THIS: http://www.automotiveforums.com/vbulletin/showthread.php?t=497839
HOPE THIS HELPS!

The solution to your problem most likely is the fuel gauge sending unit which is located on the fuel pump in the tank. SOMETIMES, the fuel pump and gauge are sold separately, but chances are, you may have to replace the whole assembly. Which is actually good measure, considering that you'll have the tank removed, anyway.

I hope this helps! :)

heater control is possible, but most likely the resister.

negative or (-) will go to ground (the body of the car or engine) follow the cable. positive will go to the starter

the operating flap isnt working ,but never done one as yet so i have no idea how to get to it

Have vehicle scanned for codes and do the repairs that the codes address.

Hi,
This sounds like the wheel balance is out and /or the tracking is out. You need to take it to the tyre shop and ask for the front wheels (both ) to be tracked and balanced. This should cure the problem.
Good luck

VSC stands for vehicle stability control and trac is traction control they are incorporated into the ABS system all receive signals from the wheel sensors you must use a digital ohms meter to find the one reading different and replace it in some cases you might find bad connections at the plugs.in any case your brakes will work fine you just wont have ABS braking or traction control

hi is the car petrol or diesel

the switch is on the conslow on tha dash

did you drop tha key one time,get an empt key with tha same frequency and have it coded

probably the security system or safety interlock. Is there a security light flashing? If not, try starting in neutral.

Please see my tip at http://www.fixya.com/cars/r6222268-engine_doesnt_crank_turn_over . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

I have a repair service for this and many other clocks/displays. Check it out www.autoclockrepair.com. Lifetime guarantee. Have repaired literally hundreds of 4runner clocks. Drop me a note if you have any questions, would be happy to assist

A dim or dead clock display is a typical symptom of a dead clock. I offer a repair service, check out www.autoclockrepair.com let me know if you have any questions. thanks

what type of problems ?

under the dash interior lite is being left on. try checking it out
after dark to see if that might be the case. also, power is
still supplied to your radio, and powers memory, could be
a short in the radio. even though the key is off.

Have you checked the fuse under the hood on the driver side?