20 Most Recent
1991 Yugo GV Questions & Answers
Yugo GV 1991 parts fit in Fiat X1/9
I have a 1991 Yugo GV that I bought for the chassis, it is being converted to electric. I believe this motor and prehaps other items may fit the Fiat X1/9 also.
5/19/2010 3:28:53 PM •
1991 Yugo GV
•
Answered
on May 19, 2010
I have a 1991 Yugo Gv Plus that starts to cease
check and replace the fuel filter on it. if if has been pluged up for to long causing the engine to run lean for too long it could have caused catelist problems too. if both are fine check fuel pressure and check the fuel pressure regulater,.
3/10/2010 7:39:00 AM •
1991 Yugo GV
•
Answered
on Mar 10, 2010
1989 yugo gv
I would check the throttle body and change the fuel filter to start, also a disconnected vacuum line can be problems too.
1/14/2009 4:08:46 PM •
1991 Yugo GV
•
Answered
on Jan 14, 2009
OVERHEATING
check coolant antifreeze check and suspect thermostat check if coolant fan coming on when needed if not check fuses and relays
Sanyo tv model ST21G1 chassis
look for the colour code on the resistor and then look it up on a chart ,different values between a silver band and a gold band but the value is the same its just the % tollerance ,gold band is a lower tolerance
How to perform engine timing
This is going to be an issue. There are marks on the gears you need to line up correctly to get it right. Without a picture to look at it is very hard. You can start and get it close by rotating the crank until the number one is up all the way and the next cylinder to fire is down preparing for the compression stroke. Then you need to turn the cam shaft until all valves are closed for the number 1 and the intake valves on the next cylinder in the firing order are closing with exhaust valves closed. This should be roughly #1 TDC, close anyway. The Haynes or Chilton's repair manual will have photos of the timing chain area and what the marks look like and instructions on how to line them up. It would be a very good investment at this point.
Not finding what you are looking for?