20 Most Recent
2005 Peugeot 405 - Page 6 Questions & Answers
Hi my 2000 peugeot 206 windscreen wipers keep
When you can't find any fault code in ecu log then in my opinion its the wiper motor that has gone. May be motor has a broken pinion which doesn't engage the wiper arms properly and causes the problem. Buy a used wiper motor from ebay and give it a try. I hope that it'll work.
P1613 fault code & engine will not rev over
Crank sensor or engine speed sensor is faulty.
Fault:
Irregular power loss on accelerating
The speed of the engine is limited till 2500rpm
Frequent loss of crankshaft position sensor signal
Cause:
It is caused due to leaking from thermostat housing into crankshaft position sensor harness multi-plug
Remedy:
Check and clean the crankshaft position sensor harness multi-plug contacts. Rectify the engine coolant leak from the thermostat housing if found. Take a note of the engine coolant level and monitor it for changes, showing a leak is indeed occurring.
Peogeot 406 gearbox moves side 2side when in gear
Well either the bellhousing bolts are loose if its moving side to side and if its moving back and forewards then its the mounting at the back of the bellhousing where mounting is fitted or the bolts retaining the mounting to the bellhousing
"when do i change the cam belt on a peugeot 307 sw diesel"
usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.
Not finding what you are looking for?