1992 Jeep Cherokee Sport - Answered Questions & Fixed issues


Could be either of the two you mentioned or dirty terminal connections or a bad starter relay. Clean the terminal contact surfaces first and then you can begin testing other components if you need to.

1992 Jeep... | Answered on Sep 30, 2018 | 219 views


the control side of relay, needs voltage and ground. As you can see, for automatic it grounds through neutral switch. For manual tranny it appears to be chassis ground. For chassis ground, I just use a redundant ground, it works for me.
starter relay-jc2kzzcm5pd40lvznzjulhkv-1-0.jpg

1992 Jeep... | Answered on Nov 19, 2017 | 149 views


It sounds as though the seals in the master cylinder have perished and aren't doing their job. The reservoir is full, yes .. but the fluid isn't getting pumped because of worn seals... there's no pressure developing.

If there are overhaul kits available - try one. They're much cheaper than buying a new clutch master cylinder. It isn't a difficult job.

0results for 1992 jeep cherokee clutch master cylinder repair

1992 Jeep... | Answered on Mar 15, 2017 | 61 views


Try some "heet" , STP gas treatment or the like. sounds like you might have some bad gas.

1992 Jeep... | Answered on Mar 13, 2017 | 84 views


If timing marks are on , distributor is out . Bring #1 cylinder up on top dead center on compression stroke an see if rotor is pointing at # 1 on distributor cap . Do you know what the firing order is on the distributor cap ?

1992 Jeep... | Answered on Apr 13, 2016 | 40 views


I'm assuming the starter is not turning the engine...check the small wire on the starter for 12v with key turned to start. If no voltage there, check ignition switch and neutral start switch. (voltage in, voltage out)

1992 Jeep... | Answered on Apr 22, 2015 | 186 views


i had the same problem with my 92 cherokee laredo, could be the crank positioning sensor. if it goes bad you dont get spark from the coil. or it could be the coil, distributor, or even spark plugs.

1992 Jeep... | Answered on Apr 22, 2015 | 231 views


Change water pump, its bad.

1992 Jeep... | Answered on Jan 08, 2015 | 92 views


go to your local hardware store, parts store and buy an expansion spring. cut it to length and bend a new tab on the cut end . fit it to the lever and it will work a treat. Most auto seats have the spring but you will have to upend a seat to get it out as it costs too much for the junk yards to do it.

1992 Jeep... | Answered on Dec 01, 2014 | 99 views


double, anon posted, why?

1992 Jeep... | Answered on Sep 20, 2014 | 80 views


fuses, check fuses first any time electrics or electronics, fail.
for ever.

1992 Jeep... | Answered on Sep 20, 2014 | 45 views


Go to jeeps unlimited post by dr righteous titled 42re Governor Pressure Solenoid and Sensor Fix. This is a in depth thread on complete repair.

1992 Jeep... | Answered on Aug 11, 2014 | 59 views


replace the fuel filter then check the air/fuel mix needle valve according to manufacturer specs. Sounds like you have way to rich a fuel mixture.

1992 Jeep... | Answered on Aug 08, 2014 | 155 views


did u follow the correct way to jump that var/suv?? there is a method,ground to the block,and pos to the pos side of the battery. then lit it charge for a few minutes, then giv it a shot. u r battery is probably beat down to nuthin. so git it towed and then u will need a new battery.??maybe? lol

1992 Jeep... | Answered on Apr 14, 2014 | 44 views


what makes you think there are bands. ?
did you look in the FSM>
did you post exact transmission in your car , ?
here is a free look 1993 chickodee.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

32RH (has bands) page 96 and 97 (band adj)
or
AW-4 no bands. uses solenoid clutch packs. electric.
see them both and all tests and settings.
is yours a TCM shifted ? tranny, yes then why not scan it.
or the flash code procedure. page 174


the TCM cars will flash OD lamp or drive lamps or something
to tell you its got error codes.
get them.

best of best. aw-4
(see the manual mode test. many cars have this, not just jeeps)
may TCM tranny cars, (RTM read the FSM and learn this)

http://mikestrawbridge.com/blog/2011/09/aw4-troubleshooting/

hint 2:
make sure the tranny ground stap is not broken.
if it is, it will never ever shift right or reliably
true for just about any TCM car.
see one guy last week bought new tranny ,and never used
a voltmeter on the solinoids. had 12v casing.. a shame.

1992 Jeep... | Answered on Feb 15, 2014 | 283 views


ever tune it up? ever , or at the 60k mile points?
if not why not.
does the CEL lamp glow running>?
rough idle is called misfire.
stalling can be many things, a mech sees this all in 5min.
here on the form i have to ask many questions (cant drive it)
lets play that out.
1: i start car and ask owner, ever tune it up,: blank stare.
2: i see it dont reach 180F coolant temp,. (bad thermostat)_
3: then note misfire. i tune it up and its fixed. or
4: it still misfires,, i find the EGR stuck open. (listed under service 60k)
5: it still misfires, i find idle too low, the ISC is stuck closed.
i clean the EGR and ISC valve and car now idles ok,
but is still rich , i find the 02 front sensor long gone bad.
it looks like it has cancer.
there are over 50 causes for misfire,
1 or all 6 cylinders. what we do is start with basics and work up.

here are 2 hints on stall.
first off the ECU failed to stop the stall, its programmed to do that
using the ISC .
so it failed to work.
the EGR stuck open will do that every time or idle at 500RPM
and shake the engine hard, misfiring.
or if one cylinder or more is dead.
or if the ISC sticks closed.

so when it seems to stall, pre-stall, as RPM drops below 800 rpm
you use a fast right foot. is it easy to prevent the stall?
easy,save, is isc stuck closed? gummed up.
harder is EGR stuck open, (but you can correct it by hard actions of right foot)?
impossible to stop the stall.?

your mech, does all that action in 5min. flat.
even loss of 12vdc power to EFI systems , do this.
(cant save it) and mech sees dash lights go dead. bingo no DC power, all by looking and seeing. and feeling.

he gathers evidence,


both my 4.0L jeeps, loved to stick the ISC.
every 20kmiles, off it cam and got sprayed with
Klondike gun lube, Dry lube. no oil , it looks like brown paint
and acts like Teflon.
The 4 liter likes to get he PCV oil mist up to the ISC,
this builds a film of gunk on the valve cone inside .
im not saying this is it, but the easy save above is a big clue.











1992 Jeep... | Answered on Dec 07, 2013 | 326 views


do you hear a motor noise if yes then flip up the rear cover at end of wiper arm and tighten the nut.it is on a spline .if no noise then tap on wiper motor and if it goes on then replace the motor

1992 Jeep... | Answered on Nov 04, 2013 | 93 views


should be near your valve cover ,,easy job

1992 Jeep... | Answered on Oct 25, 2013 | 17 views


check the throttle position sensor and the wiring,it will mimic trany problems when it going bad or already bad,or have a bad signal from a bad wire.

1992 Jeep... | Answered on Oct 10, 2013 | 31 views

Not finding what you are looking for?
Cars & Trucks Logo

289 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 Jeep Cherokee
1998 Jeep Cherokee

1,365 Questions

1999 Jeep Cherokee
1999 Jeep Cherokee

1,143 Questions

1995 Jeep Cherokee
1995 Jeep Cherokee

687 Questions

2000 Jeep Cherokee
2000 Jeep Cherokee

657 Questions

2001 Jeep Cherokee
2001 Jeep Cherokee

643 Questions

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...