20 Most Recent 1985 AMC American Motors Eagle Questions & Answers


Thank you for this tip. There are a lot of 4x4 that use vacuum to engage the front drive.

1985 AMC... | Answered on May 06, 2019


you can easily the repair and service manual from the given link http://toolsnyou.com/

1985 AMC... | Answered on Nov 13, 2017


Go to the AMC Eagle Den and sign up for the forum, then ask this question there. Great place if you want to keep your Eagle up!
Welcome to the AMC Eagle Den

1985 AMC... | Answered on Feb 02, 2015


Replace the valve cover gasket and use black RTV to seal it.

1985 AMC... | Answered on Nov 06, 2014


Replace the jets in the carburetor with 2 sizes larger jets and the hesitation will disappear. FIRST though, look in the carb and open the throttle with your hand at the same time to see if fuel is being squirted into the venturi's, if not then you need to replace or adjust the squirter. This is what causes hesitation on acceleration.

1985 AMC... | Answered on Nov 06, 2014


go to alldata.com thay have most everything,as long as the maker had it out there to get

1985 AMC... | Answered on Apr 12, 2014


I could help you if you could add some images!

1985 AMC... | Answered on Mar 01, 2011


The EGR valve is unserviceable which causes a bad or insufficient fuel control for em-missions......Hope this helps you out........EGR valves are not very expensive.

1985 AMC... | Answered on Oct 12, 2010


remove the air cleaner and get a can of carbi clean and spray a small amount into the carbi while the engine is off then start the engine and run it a bit, you can also spray a small amount of cleaner into it when it is running but you will wnat to be carfull not to cause a fire, if you are un shoure it may be best to take it to a mechanic

1985 AMC... | Answered on Oct 02, 2009


Loosen the top bolt and use a bar to pry outwards on the alternator till it moves to it's tightest spot to tighten the belt. Then tighten the top bolt while holding the alternator out with the bar. You're done.

AMC Eagle Cars &... | Answered on Nov 06, 2014


Fill the master cylinder with brake fluid, leave the cap off, open bleeder on left front wheel cylinder till fluid begins to come out and close the bleeder. Go to the right front and bleed it, this is gravity bleeding and works fine without a helper to pump the pedal, when fluid starts to come out close bleeder. Now go to the right rear and bleed it the same way. Then lastly, the left rear. Bleed it and you should be done and with a good pedal. If you don't have good pedal, you'll need someone to pump and hold the brake down as you bleed each one from the closest to master cylinder around to the farthest from it in sequence. It's the only way to bleed brakes.

AMC Eagle Cars &... | Answered on Nov 06, 2014


Yeah, You're right on the position of the solenoid, and you hook the side large post to the hot post of the battery with large cable, and the large post on other side of solenoid to the starter with the large cable. The single wire that comes from the starter switch goes on the small post to the front, and if theres a second small post, it doesn't have to nave a wire on it, but normally it is a power cutout to other things that are not needed to be powered when cranking. Use a test light and have someone crank the engine over to test and see for sure which wire is the one coming from the switch before you connect it.

AMC Eagle Cars &... | Answered on Nov 06, 2014


Right turn is green, left turn is yellow, running lights is brown. This is same on all vehicles in the USA.

AMC Eagle Cars &... | Answered on Nov 06, 2014


If starter is good still, Check the battery connections on the battery and at starter. Clean then shiney. Check also the solenoid wire connection from the switch at the starter solenoid. Be sure it's clean and tight also. Then just be sure the battery is up to par.

AMC Eagle Cars &... | Answered on Nov 06, 2014


d/s under dash area

AMC Eagle Cars &... | Answered on May 28, 2014


P/S on the motor 232 or a 258

AMC Eagle Cars &... | Answered on May 28, 2014


Well you going to need to lift the car and then disconnect the cable from the transmission on the driver side and then inside remove the shifter cover and disconnected from there and reverse the process

AMC Eagle Cars &... | Answered on May 28, 2014

Not finding what you are looking for?
Cars & Trucks Logo

17 questions posted

Ask a Question

Usually answered in minutes!

Top AMC Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

5954 Answers

Are you an AMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Eagle AMC

  • Eagle AMC

Most Popular Question

go out in am car

  • Cars & Trucks
Loading...