20 Most Recent
1996 Lincoln Town Car - Page 5 Questions & Answers
How to replace heater core
Hi Quinton, I'm glad to help!
Quinton, this is a job that's very hard if you've never repaired cars before. The entire dash must be removed to gain access to the heater box that must also be removed to change out the core. You can google: how to replace heater core on 96 Lincoln town car. This will give you video's on how its done and give you an idea of the work involved. Hope this helps and have an awesome day Quinton.
Which fuse is for the trunk lid release
There is a motor back there. You gently push the trunk lid down, then the motor pulls it closed. Fuse #8 15 amp, but usually people damage this system by slamming the trunk lid, then the motor needs replaced. I hope that's not the case; they are $$$ not cheap. if the door locks and the power mirrors work, this fuse is good.
Why would a 1993 lincoln town car driver window roll up ?
this can happen when the power switch has a fault , if you want to make sure it stays up and not come down when not wanted , as can/will do this as well as go up ,remove the fuse for the power windows until you get the switch replaced
Why whould i have water in my moter oil
there could be several reasons why you have water in your motor oil #1 blown head gasket #2 cracked cylinder head. You need to do compression check on all cylinders.that would be the place to start.
Where are the freezeplugs located on a lincoln towncar 1996
According to Haynes Manual, for a 4.6 OHC motor, the Freeze plugs are located about 3-4 inches below the cylinder head, under the exhaust manifold. The back plug is 5-6 inches in front of the bell housing on the block. They are pictured on page 2C-21 of the Manual in section 15 Engine Block Cleaning..
How are the electrical connections on an alternator removed?
One is covered with a red rubber cover, this one is held in place by a nut. Pull the rubber back and remove the nut. The other should have a tab that releases the plug. The tab needs to be pushed out to release. If there is no tab then in should pop out by prying around the edges with a screw driver.
Not finding what you are looking for?