1997 Hyundai Elantra - Page 2 - Answered Questions & Fixed issues


Have the fuel pressure checked after it sets over for a few hours.

1997 Hyundai... | Answered on Nov 12, 2013 | 40 views


it is very possible that when the pump/fuel level sender assembly was reinstalled, the fuel lever float binded preventing it from floating to indicate proper fuel level, or the fuel level sender plug isn't plugged in at the fuel pump.

1997 Hyundai... | Answered on Nov 12, 2013 | 36 views


Its on the bottom of the tank with washer fluid.

1997 Hyundai... | Answered on Nov 11, 2013 | 75 views


See exploded view
0d68e80.gif

REMOVAL
1. Drain the coolant down to thermostat level or below. 2. Remove the coolant outlet fitting and gasket. 3. Remove the thermostat

1997 Hyundai... | Answered on Jul 16, 2013 | 2,307 views


You can exchange it with one that is inner cooled and turboed But thats $1500.00 in parts plus the engine and labor. Your best bet is to find out what is wrong with your engine and rebuild it. As long as there are no major damages.

1997 Hyundai... | Answered on May 14, 2013 | 304 views


Power windows work either by direct gears or through a cable attached to the motor. In most instances the cable brakes and you may have to by a complete unit. check with a spares department an decide on either a new one or one from the wreckers

1997 Hyundai... | Answered on Mar 02, 2013 | 57 views


The public library will have either "Alldata" or "Mitchell on Demand" which will show component locations for your car. Also some part stores can also tell you where that is located.

1997 Hyundai... | Answered on Dec 08, 2012 | 69 views


Ok....what do you want us to do about it? Take your car to a mechanic. Unless your just not pressing the clutch....

1997 Hyundai... | Answered on Nov 14, 2012 | 31 views


Rarely a fix for that --other than a rebuild

May want to have a trans shop check it out

I will guarantee you that they will want to rebuild it
necessary or not.

If it is original from 1997 then it's all over,go for for a reman
or rebuild yours

Going forward --- you change trans fluid as well as power steering,
every 3 years period, or keep your check book handy (all vehicles)

1997 Hyundai... | Answered on Oct 02, 2012 | 30 views


check with a auto parts store and see if that model had a option without ac and get a belt for that

1997 Hyundai... | Answered on Sep 10, 2012 | 58 views


Hi there:
Two ways it could be a lack of fuel. Low fuel pressure or lack of injector pulse. Low fuel pressure is usually just a bad or weak fuel pump.. but you would want to check power to the pump when this happens before replacing it.

Injector pulse would be too low based on an input to the computer. These would include the coolant temp sensor, tps and mass air flow sensor.

Just a hit, sometimes the purge valve leaks fuel vapors into the intake and causes a hard start condition. However, this usually causes the engine to be flooded.. or have too much fuel or fuel vapors.

Other posibilitie could be the CKP (Crankshaft Position) sensor, but rare.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

1997 Hyundai... | Answered on Jul 21, 2012 | 383 views


What problems are you having?
There is no list of common vehicle
faults. All vehicles suffer the same fate

1997 Hyundai... | Answered on Jul 09, 2012 | 67 views


Throttle position sensor, check that, or fuel pump/filter

1997 Hyundai... | Answered on Jul 02, 2012 | 582 views


What is the problem with the rack n pinion ? What problems are you having with the car, please make sure to list the engine size and car info again.

1997 Hyundai... | Answered on May 28, 2012 | 103 views


need to check for transmission codes to make sure you don't have a bad shift solenoid if it an automatic. if it is a manual shift check the clutch disc for wear.

1997 Hyundai... | Answered on May 24, 2012 | 164 views


This is a situation where the onboard diagnostics is not monitoring the defective part. In this case you must trial and error a solution starting with the cheapest part or the most probable bad part.
In the old days a problem like yours would point to a bad coil. But many of the newer cars have coils on each sparkplug or 2 or more groups of coils. You then would have part of the system working and would find spark in part of the wiring.

Since you have no spark at all, a controlling part for the entire system must be bad. If you have but 1 coil on your model, change it. But look to other parts like Ignition relays, crankshaft or camshaft sensors or the Powertrain control module for defects.

You can get a fusebox or powerbox diagram at Autozone.com when registering your car for FREE. Then you will know where the proper Relay is if you do not have an Owners manual.

There may be a defect in the safety mode of the engine controls which are suppose to engage a LIMPHOME mode to keep you running when an engine overheats. It would be a defect if it killed the engine instead of limiting RPM and other dash indicators should light up.

Besides trying a new coil or Relay about all is left is an attached monitoring device which a Dealer mechanic would use to drive your car until it fails. These better monitoring devices record things directly and can bypass the onboard system, which allows previously unmonitored systems to be observed.

The failure is recorded on this added on device and it can make difficult to solve problems apparent to the mechanic. Sometimes it is the only way to catch a defect in he act. Depending on the parts prices, guessing can be more expensive than using this Dealer device.

If I was accurate, please let me know the outcome as some others may have future problems I can solve knowing this.

1997 Hyundai... | Answered on Apr 24, 2012 | 135 views


you have an override toggle switch hidden somewhere under dash youll have to search for it.

1997 Hyundai... | Answered on Apr 07, 2012 | 3,004 views


cooling fan not turning on it should also turn on with the a/c

1997 Hyundai... | Answered on Apr 05, 2012 | 25 views


Could be a lot of things.

Thermostat
Coolant pump
Low coolant
Blown head gaskets
Plugged radiator

1997 Hyundai... | Answered on Mar 22, 2012 | 31 views


There is a special puller tools you may need if the pulley does not pull out after removing the center bolt. This puller has two bolts included in the kit that thread into two holes on the pulley to help extract it.

1997 Hyundai... | Answered on Feb 04, 2012 | 35 views

Not finding what you are looking for?
1997 Hyundai Elantra Logo

289 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...