Top 20 1995 Hyundai Scoupe - Page 2 Questions & Answers

En la caja de fusibles el fusible es el numero 8 es de 15Ampers

Go to carhelpsite.com it is free as long as you click on 2 of the ads at the website then your questions will be answered by an ASE certified mechanic,you don't have to buy or fill out anything on the ads,so help keep the site free.

does this car have a delay or warmup loop will not shift till the temp reaches the 192 of the thermestat. kia 's do and some of the hyundai's
if all is fine check the mass airflow sensor unless it has a carb
make sure the throtle plates in the tbi are working

NO IF CRANK CASE OIL LOOKS OKAY.AND YOU NOT GETTING HEAVY WHITE SMOKE OUT THE EXHAUST HEAD GASKET NOT THE FAULT. ONLY MOISTURE IS WHAT IT IS. BUT HAVE IT SCANNED TO SEE WHAT CAUSING CHECK ENGINE LIGHT TO COME ON.

tighten the bolts after pulling alternator forward to tighten the belt. also tighten the rear bolt so it dosnt move

is it a Scoupe or a toyota matrix????????? I dont think you can legally turn it off. Why would you want it off.

Ther are two bolt just below the front of the seat that are usually hidden by carpet,remove them and lift the front up then pull forward.

Yes, sounds like it's low on refrigerant. You can buy a kit and do it yourself but I feel it should be vdone by a n a/c tech. For many reasons. Improperly done more problems may develope. Good luck

they are identical so is the block

You can try taking out the spark plugs, pour about 2 oz of marvels mystery oil in the cylinders, and let sit over night. Try turning it over in the morning. This may or may not work.

Any locksmith should have this blank and be able to cut it, the blank you are looking for is an Ilco X196

Check the idle air control valve( IAC) just inside the fuel neck where the air duct work is located.
Or have the car scanned for a trouble code if the IAC is not the problem. it could be several sensors that one of them may have failed.

I would say it would be 5w30 but the oil cap would say

yes, replacing this fusible link will correct this issue. it seems to have a short of some sort.

Do you mean the camshaft bearing caps? What size are the heads?

When you crank the engine the fuel pump powers on for approximately 3 sec. pressurizing system.....once vehicle starts the power will be continuous....

Most likely the incorrect bulb was installed or a faulty bulb, causing an electrical cross over. Replace the bulb, and check socket.

have a look at link:
http://www.expresspaint.com/helpful_tips/color_location_guide.asp#infinity

Hi paul this starter will be able to be used. same part number same starter. hope i helped thanks.

If you hear a click under the hood from the starter the starter solenoid but starter is defective and you should rebuild it. If that is not the case I would replace the ignition starter switch, this is the electrical switch the key cylinder actuates to turn on the electrical system and engage the starter.