Hyundai Motor 1995 Accent - Answered Questions & Fixed issues

Causes of white smoke when car is cold idling

remove door panel which is attached by screws,peel away plastic liner and look inside door at back of door handle..using needle nose pliers pop off the small steel rods that are for inside door mechanism,then remove the one bolt that attaches the handle to the inside of door and from outside of door remove handle.Replace in reverse order!

Check if the ignition wires are re-installed with the proper firing order (should be 1-3-4-2) cylinder 1 is closest to the passenger side fender.

Try changing your fuel filter, if that does not fix your issue I would have the catalytic converter changed.

Varies in all cars according to engine. No such length.

This may be from a dry pivot bush or spring squeak. It can also be from a failing clutch master cylinder or a failing clutch cable

what kind of vehicle is it?

Your air/fuel mixture is too rich so it's choking out the engine. Get your mechanic to adjust the carburetor.

misfiring can also be cause by low fuel pressure and injector faults . I would eliminate the low fuel pressure by having a fuel pressure test as it checks the fuel, pump, filters ,pressure relief valve and fuel pressure sensor that controls the fuel pump. Basically if the pressure is not high enough then the injectors do not get to let in enough fuel and so a misfire occurs

i'd try a fuel addative to clear through fuel,cylinder/valves and the cat converter may have a carbon/sludge build up ,cheaper than getting iac and the idle may be the blockage symptom give it a go nothing to loose,must have quite a few miles on it

HAVE THE IGNITION SYSTEM CHECK,ALSO THE IACV(IDLE AIR CONTROL VALVE)IF THERE IS ONE.

Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

check your fuses

You may want to have your catalytic converter inspected to see if the internal components are broken and possibly clogging your exhaust flow.

if it is a wurring sound that speeds up with the cars acceleration it is probably the bearing in the hub assembly. if so replace assembly

HelloThe engine and automatic transmission in this vehicles drive train are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM

i believe that is different on each vehicle and would have to get that info from the manufacture. the cods are placed as a anti theft. so if the radio came out of a different vehicle you will need that vehicle info as well.

Below is the diagram you needed. This is an updated one per ALLDATA as some changes were made so the one below it with the X over it is the wrong way that many manuals are saying. It's done in two passes for final torque I hope this helps and good luck.

Have a look at the plugs, may be dirty or faulty. Look for cracks in the distributor cap.