1990 Porsche 911 Carrera - Answered Questions & Fixed issues

0helpful
1answer

How do I unlock interior front trunk release for 1990 Porsche 911 will not unlock with any key I have

I suggest a locksmith. They can make a key to unlock it for you.
11/5/2014 12:18:10 AM • 1990 Porsche 911... • Answered on Nov 05, 2014 • 125 views
0helpful
1answer

1990 c4 wont start

Check connections to ECU under pax seat I believe, possibly a failed ECU, make sure you buy a new coil as well if replacing ECU.
3/29/2014 4:21:56 PM • 1990 Porsche 911... • Answered on Mar 29, 2014 • 94 views
0helpful
1answer

1990 964 wont spark

run the fault codes first as there are a number of reasons for no spark --the last being the coil. There is an ignition module ---position sensors --timing belt --shorts in the cap --bad coil lead to the distributor . The ignition module may be only have 7.5 volts to it from the coil in which case you may have burnt it out with the 12 volt application and you will not get any spark unless the coil is in the circuit as it is a transformer that generates the high voltage necessary for a spark at the plugs.
3/16/2014 1:09:01 AM • 1990 Porsche 911... • Answered on Mar 16, 2014 • 329 views
0helpful
1answer
0helpful
1answer

Key will not turn on anything intermittently, but then 15 minutes later, will work normally

if the key will not TURN the ignition try spraying alittle wd40 into it ,just a quick shot then run the key in and out a few times .if it turns but won'tstart check your battery connections ,may need cleaning and tightening. if lubing ignition does not work you may need a newly cut key a twenty year old key may be worn out.see a locksmith or dealer
9/23/2012 6:30:50 PM • 1990 Porsche 911... • Answered on Sep 23, 2012 • 167 views
0helpful
1answer

1990 porsche fuel pump relay location

hello thereyou fuel pump relay is called DME relay and it is in your trunk fuse box.Take the cover of and you will see it marked as DME proporsche
10/16/2011 7:45:30 AM • 1990 Porsche 911... • Answered on Oct 16, 2011 • 875 views
0helpful
1answer

Electric seat will tilt back but cannot tilt back forwad

I DON'T THINK THEY HAVE MANUALLY DO THAT. YOU MAY CHANGE SWITCH TO OTHER WORKING SWITCH. THAN IT DOES NOT WORKING YOU MAY HAVE PROBLEM WITH MOTOR. I HAVE 1990 C4 SAME PROBLEM. BUT I CHANGED MOTOR IT WORK.
7/1/2011 1:13:37 AM • 1990 Porsche 911... • Answered on Jul 01, 2011 • 285 views
0helpful
1answer

1990 Porsche 911 Carrara 2 Targa. power window not

YOU TWO WINDOWS NOT WORKING OR ONE OF POWER WINDOW NOT WORKING. IF YOU HAVE TWO WINDOWS NOT WORKING YOU SHOULD CHECK THE HUGE BOX. IF ONE WINDOW NOT WORKING YOU SHOULD FULL OUT WORKING WINDOW SWITCH AND REPLACE WITH NOT WORKING SWITCH. IF IT DOES NOT WORKING YOU HAVE POWER WINDOW MOTOR.
6/19/2012 4:19:52 PM • 1990 Porsche 911... • Answered on Jun 19, 2012 • 810 views
0helpful
1answer

Where can i find a

hello there
the best would be to contact your nearest Porsche dealer and ask them for a copy.It is large format .
What is your problem? I will try to help you.
[email protected]

proporsche
6/17/2011 11:21:25 AM • 1990 Porsche 911... • Answered on Jun 17, 2011 • 216 views
0helpful
1answer

Car was shifing fine...now is

check the gear oil in the transmission Porsche is notorious for trans problems, and it wouldn't surprise me if it was leaking. too low a fluid and it will not go into any gear but the one that was last selected.
4/18/2011 6:21:01 AM • 1990 Porsche 911... • Answered on Apr 18, 2011 • 405 views
0helpful
1answer

1990 Porsche 911 Carerra 2

YEP SHIFT LINKAGE LOOSE OR WORN NEED ADJUSTMENT.ADJUST THE SHIFT LINKAGE BY POSITION THE SHIFT LEVER IN NEUTRAL .REMOVE THE REAR TUNNEL COVER IN FRONT OF THE REAR SEAT.PULL THE RUBBER DUST COVER FORWARD ON THE SHIFT ROD.LOOSEN THE CLAMP BOLT ON THE SHIFT ROD.MOVE THE TRANSMISSION SELECTOR SHAFT ALL THE ITS LEFT STOP,KEEPING IT IN NEUTRAL.WITH THE TRANSMISSION STILL IN NEUTRAL . MOVE THE GEARSHIFT ROD TO THE RIGHT TO ITS STOP.TIGHTEN THE CLAMP BOLT TO 18 FT LBS.TEST THE SHIFT LEVER PLAY SHOULD BE THE SAME IN ALL GEARS IN ALL DIRECTIONS.
4/18/2011 6:09:42 AM • 1990 Porsche 911... • Answered on Apr 18, 2011 • 811 views
0helpful
1answer

Do you know where I

Check Amazon.com or Pelican Parts.com
4/7/2011 9:46:45 AM • 1990 Porsche 911... • Answered on Apr 07, 2011 • 343 views
0helpful
1answer

Can i manually operate the top on my 1990 911

hello there
most of the cabriolet in 1990 are electrical.
If you like to open manualy it is posible only if you disconnect the arms which are attached to the motors on each side .The arms and motors are located behind the side panels.Disconnect only the connection to the arms not the arms from the motors,there is an allen head bolt to be removed.Aftrer this you will still need to operate electricaly the two (on the top of the windshield ) el.motors(latches).
If you use the switch to detach the top from the windshield then you can finish the openning by hands(manualy) this is the only way it would work for you.

Let me know if you need more help
[email protected]

proporsche
1/29/2011 7:49:05 PM • 1990 Porsche 911... • Answered on Jan 29, 2011 • 220 views
0helpful
2answers

Porsche 1990 carrea 2 hood latch not working

With a rarchet, extension and socket remove the bolts holding the latch to the core support and the hood will open. The cable usually just fell off. reattach or replace as needed.
1/6/2011 6:43:37 AM • 1990 Porsche 911... • Answered on Jan 06, 2011 • 406 views
0helpful
1answer

1990 Porsche 911 Carrara 2 Targa. Slight smell of

that oil leak or another is dripping on to the exhaust manifold or exhaust pipe ,that is where it is coming from,,
11/15/2009 12:22:49 AM • 1990 Porsche 911... • Answered on Nov 15, 2009 • 1,341 views
0helpful
1answer

1992 porsche carrera convertible top won't open.

Replace the top motors or check cables from motors to top. There are 2 motors one for each side of the top.
6/18/2009 7:35:45 PM • 1990 Porsche 911... • Answered on Jun 18, 2009 • 674 views
0helpful
1answer

Cannot shift into reverse although forward gears all functional

have ur shift linkage bushings replaced....most likely thse are torn or completely broken .. this is common on these models..also on some vw's of the same years
4/10/2009 6:15:10 AM • 1990 Porsche 911... • Answered on Apr 10, 2009 • 1,001 views
0helpful
2answers

Problem with spoiler manually work on position down but not go up

There is a similar problem with such spoilers. Check this site for the same issue: http://www.crossfireforum.org/forum/crossfire-coupe/50531-spoiler-stuck-up.html
4/20/2015 4:17:45 PM • Porsche Carrera... • Answered on Apr 20, 2015 • 725 views
Not finding what you are looking for?
1990 Porsche 911 Carrera Logo

42 questions posted

Ask a Question

Usually answered in minutes!

Top Porsche Experts

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Porsche Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...