20 Most Recent
1997 Land Rover Discovery - Page 5 Questions & Answers
My 1997 landrover discovery
This can be due to the possible reasons as follows:
1. Fault in the door switch , rocker switch contact being faulty.
2.Fault in the wiring harness that has snapped at the door hinges section.
3. Fault in the winding motor., remove and check for forward backward movement.
4. Mechanical jamming of the winder, remove and reset if there is tightness in the glass channel.
5.Fault in the electronic circuit/ load trip off circuit.
Where is the fuse for the fule pump in a 1997
the fuel pump fuse is in the engine compartment fusebox. if you are looking from the front of the car into the engine compartment you will see a little black rectangular box on the left side towards the front of the engine. gl
Is there a way to reset the check engine light on
First off, you never have to set foot in a
dealership in your entire lifetime
The O2 Sensor, I hope you changed
yourself. That was a 10 min job
Disconnect the battery and see if the code clears
Some O2 codes clear when the new sensor is installed
P1193 code
inlet air temp sensor volts too high
most likelt the idle air temperature sensor is bad or has a problem in the circuit it self
I changed the battery in
So if you were to pay a dealer for their time & have it
taken into the service bay, not a single tech could put
in a radio code
That is pure non sense
Sorry, I had to say something & I don't have your owners
manual or any other material to help you
Try asking another dealer, or see if you can have it
done with a scan tool at a local repair shop
Removal of the starter on a 1997 LR
Disconnect negative battery terminal. From underneath the vehicle, remove the skid plate & heat shield, if you have one. Disconnect the wires from the starter solenoid, pay attention to placement, they will need to be reinstalled the same way. Loosen the bottom starter mount bolt 3-4 turns & remove the top one. Holding starter in one hand, remove the bottom bolt and pull starter straight out from flywheel. Hope this helps.
My 1996 landrover discovery is
When was the last time that you change the engine oil?
Sometimes it does that whe you have an excess of oil, check the level.
But definitve white smoke means oil being burnt in the engine, you only see it in park because the smoke doesn't disperse like in motion.
My landrover discovery 1, v8,3.9
Yes it should be in High, unfortunatly the Land Rover discovery does not have 2 wheel drive capability. Unless one of the shift modulators is stuck then what your seeing is normal. There are kits available to change the gear ratio on the transfer case to get lower revs. I belive they are called a Disco box. This will decrease the torque and increase the power needed for take offs but will reduce the engine revs
Im looking for an on-line
Telephone: Fax: VAT Registration No.:
Notes Specified value Measured value
Ignition system
Ignition coil Make Bosch
Ignition coil Type 0 221 122 392
Ignition coil supply voltage + with ballast V 11,0
Primary resistance Ohm 0,67-0,82
Firing order 1-8-4-3-6-5-7-2
Distributor (ECM) Make Lucas
Distributor (ECM) No. 42583A
Contact breaker gap/trigger air gap mm 0,20-0,35
Cylinder layout
Manufacturer: Land Rover Model: Discovery (90-98) 3,9 Engine code: Output: 134 (182) 4750 Tuned for: R-Cat Year: 1994-98
© Autodata Limited 2007 14/05/2011 V6.410-
8 7
6 5
4 3
2 1
looking from front of disco
I have a 2 dr 1997 disco how much of a job is it
big job but doable.
welding in new 50x100 3mm box section instead of soft sills as this wont rot out and you get funky rock sliders built in!
bit of fabricating of body to chassis mounts but no harder than welding in after market panels. good pics on lr4x4 forum.
MY LANDROVER DISCOVERY CAR RADIO
You need to introduce in it the security code - it's a 4 digit number that is specific to that radio. The number can be found in the purchase papers and the user manual of the car, along with the instructions on how to input it.
The internal lights stay on. I've checked the door
You might want to check wires (backside of switch(s)) to see if any have crossed or try disconnecting each switch, one at a time - possible internal short. If all else fails download this: Rave man. It has wiring schematics - http://www.landroverresource.com/
Not finding what you are looking for?