20 Most Recent
2001 Kia Spectra - Page 4 Questions & Answers
Kia spectra wont start
it is probably the starter assuming the engine isnt locked up. I would check to see if you have battery voltage at the starters solenoid wire with the key in the start position if you do i would check the fuses and starter relay
Where is the spare tire
Lift up the stiff cover (it's like heavy cardboard) at bottom of trunk. That's where the spare is usually stored.
My 2001 Kia Spectra, automatic transmission, has
if your vehicle required brake application prior to shifting out of park your problem exists in the switch at the brake pedal, the solenoid that unlocks the shifter control a fuse or the wiring between them.
Blower motor not always working
when wired to the battery it's getting full power.
so if the switch is set to anything but max it won't get full power. does it work on max?
does the fan stop and start over bumps? will it come on if you wiggle the wires? check those.
if there are no loose wires and the fan is not jammed in the heater box try a new motor.
My alternater and battery test good on my 01 kia spectra.But, After putting the fully charged battery in my car, it slowlky died in on ly a few blocks drive?
Connect an ammeter in series with the battery positive terminal and battery positive lead. With ALL systems off, including alarm, door lights etc and with doors closed you should have a reading of only 0.03 amps.I'm guessing that yours is higher as it sounds like you have a parasitic voltage drain.If indeed it is higher, then disconnect any alarm system first and check your amps again. Every time you disconnect something, go back and check your amps.Once you get your amp drain back to normal, then you have managed to disconnect the system responsible for the high current drain.The most likely candidates are always the alarm system, then stereo, then GPS tracker. After that you will have to start pulling more fuses, one by one and letting the vehicle rest for a few minutes after each thing is disconnected before taking a reading.BTW, if it is the alarm which is drawing a high amp drain, then it is more often than not the alarm siren back up battery which has failed.Good luck.
Heats stays on
sounds like the heat control valve is sticking could be a vaccume line off
Not finding what you are looking for?
See picture below.
