20 Most Recent 2003 Jaguar S-Type - Page 7 Questions & Answers

in the codes for misfire there is also an injector and fuel pressure result . It is not always the plug and coil. have a fuel pressure test done as well and have the injectors and electrical connection checked.

Check transmission fluid in g/box is not burnt Re: Jeff

Call your service provider, they will guide you how reset it to default settings. Then u can reset your preferences

air gap on rear abs sensor reluctor rings fouling sensors due to corroded swollen rings. add washers under sensors .make sure all tyres are correct size/aspect ratio e.t.c also front abs sensor leads part of sensor i think are suspect, check fault codes in abs module if it a comparsion fault code its more than likley the rear reluctor ring air gaps

YES OR A RELAY NOT POWERING THEM UP OR STOPPED UP FILTER

Are the lenses clean?

try replacing the fan stat, usually on the rad

If it is coming from radiator cap I would say it's the seal on the cap. Change the radiator cap.

The starter is usually under the vehicle.

its on the fan housing

sounds like torque converter and/or drive plate problem. gearbox out to locate cause.

the traction control works in conjunction with the abs if the abs light is on you have a problem with that system you need access to sutiable diagnostic equipment to check and clear dtc,s

Could be either system since they are connected. The regular brake light will come on if the hydraulic fluid level drops, or if the parking brake is on.The ABS light comes on if there is a problem in that system and it should set a trouble code like the engine computer does.