20 Most Recent 2002 Jaguar X-Type Questions & Answers


need to take it in and diagnose

2002 Jaguar... | Answered on Nov 03, 2019


P1646 is a faulty heater circuit on bank 1 upstream o2 sensor. If you have the V6 2.5 petrol engine, then bank 1 is the exhaust manifold nearest the bulkhead ( firewall if you in the states). Replace the upstream o2 sensor. Cost around £70from dealer...not available elsewhere.

2002 Jaguar... | Answered on Sep 22, 2019


p1647 is linear o2 sensor control chip bank 2 p1111 is intake air temp sensor

2002 Jaguar... | Answered on Jul 16, 2019


google search your VIN number

2002 Jaguar... | Answered on May 09, 2019


get your car scanned and reset the light

2002 Jaguar... | Answered on Jan 31, 2019


To the right (UK)/left(US) and on the dash below the sterring wheel level (near Fog light switch) you will see three buttons A B and Reset. With dash display showing trip millage of the one you wish to reset (A or B) press and hold the reset button for 5 secs.

Vist http://www.bluejag.co.uk for other useful info on your X-type

2002 Jaguar... | Answered on Nov 30, 2018


i have a jaguar 2002 2.5 had my transmission fix does the oil pan need to come off

2002 Jaguar... | Answered on Sep 23, 2018


YOU DONT HAVE TO REMOVE THE ENGINE.YOU HAVE TO REMOVE NEGATIVE BATTERY CABLE TURN OFF RADIO FIRST TO KEEP FROM LOSING CODE.YOU HAVE TO REMOVE THE ACCESSORY DRIVE BELT.REMOVE THE VALVE COVER.REMOVE THE TIMING CHAIN COVER.REMOVE THE SPARK PLUGS.REMOVE CRANKSHAFT POSITION SENSOR PULSE WHEEL.YOU WILL NEED A 2004 CHILTON EUROPEAN SERVICE MANUAL TO SEE BOTH TIMING CHAINS LINKS MARK LOCATION.THIS IS A IMPOSSIBLE TASK WITH A REPAIR MANUAL.. BUT YOU DONT HAVE TO REMOVE THE ENGINE.

2002 Jaguar... | Answered on Aug 27, 2018


All fault codes can be checked out at http://www.bluejag.co.uk but here are the results for some of yours. You can ignor P1111. Looks like a faulty plug or coil pack cylinder 2

Fault Code:- P1314 Indicates a Power-train fault


The fault is generally due to a problem in the Ignition or Misfire area


Fault Description: Misfire rate catalyst damage -bank 2 NOTE: This DTC will flag only when accompanied by an individual cylinder misfire DTC: P0300 - P0306

Action of ECM:- ECM Default:- Maximum engine speed reduced


After clearing the DTC, complete the Misfire monitor drive cycle
Check for a reoccurrence of fault DTC.


Possible Fault:- Cylinder compression low Worn camshaft / broken valve spring(s) Fuel delivery pressure (low / high) Fuel injector(s) restricted / leaking Fuel injector(s) continuously open Fuel contamination Fuel injector circuit fault(s) (Injector DTCs also flagged) Spark plug failure / fouled / incorrect gap ECM to ignition coil primary circuit fault (Cylinder misfire detected DTC also flagged) Ignition coil failure
Fault Code:- P1316 Indicates a Power-train fault


The fault is generally due to a problem in the Ignition or Misfire area


Fault Description: Misfire excess emission NOTE: This DTC will flag only when accompanied by an individual cylinder misfire DTC: P0300 - P0306

Action of ECM:- none


After clearing the DTC, complete the Misfire monitor drive cycle
Check for a reoccurrence of fault DTC.


Possible Fault:- Cylinder compression low Worn camshaft / broken valve spring(s) Fuel delivery pressure (low / high) Fuel injector(s) restricted / leaking Fuel injector(s) continuously open Fuel contamination Fuel injector circuit fault(s) (Injector DTCs also flagged) Spark plug failure / fouled / incorrect gap ECM to ignition coil primary circuit fault (Cylinder misfire detected DTC also flagged) Ignition coil failure

Fault Code:-
P0302 Indicates a Power-train fault


The fault is generally due to a problem in the Ignition or Misfire area


Fault Description: Misfire detected ?€" cylinder 2

Action of ECM:- none


After clearing the DTC, complete the Misfire monitor drive cycle
Check for a reoccurrence of fault DTC.


Possible Fault:- Refer to P0300 Possible Causes

2002 Jaguar... | Answered on Jul 26, 2018


Not all X-Type has the Bluetooth device factory installed, even if the radio buttons says so.

2002 Jaguar... | Answered on Jul 10, 2018


PCV hose. I had the same problem...Hear air escaping from mine..I just put some hose tape over mine, and when I got the cruise not available and check engine again, sure enough..tape was coming off...replace the hose..problem solved.

Felicia

2002 Jaguar... | Answered on Apr 19, 2018


I know this website www.reliable-store.com that i get manuals from, and they have all models online that solve all simple/technical problems like professionals

I also brought for my 1989 BMW, such old model, they had it and it was very good manual. Go ahead, I bet.

2002 Jaguar... | Answered on Mar 14, 2018


check door latch sensor. seems to be a common issue.

2002 Jaguar... | Answered on Mar 03, 2018


if your xtype is awd then its a petrol/gas engine and you should get the exhaust system checked. the humming sound is more than likeley a wheel bearing front is favorite

2002 Jaguar... | Answered on Mar 03, 2018


it sounds the switch has not been adjusted correctly the way is to start the engine then hold the brake pedal on with the new switch unlocked

2002 Jaguar... | Answered on Feb 21, 2018


Visit the on-line store, known as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

2002 Jaguar... | Answered on Feb 19, 2018

Not finding what you are looking for?
2002 Jaguar X-Type Logo

2,477 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

X-Type Jaguar

  • X-Type Jaguar

Most Popular Question

2002 jaguar x type brake light switch

  • Cars & Trucks
Loading...