Top 20
2002 Hyundai Accent - Page 7 Questions & Answers
Start difficult,run unevin
If your vehicle is struggling to start and idles very rough then it usually symbolizes that you need a tune up. Without more information though I am limited on the advice I can give. I would suggest replacing the spark plugs and possibly the wires if need be. Maybe try a fuel cleaner I know there are a few popular ones out there like Techron that can clean out your injectors pretty well. Once you have completed that and the issue persists then you may have other issues such as the Throttle Possition Sensor could be going out again not sure without more information.
Why is my gear shift so hard to move??
I believe your clutch is not disengaging fully. When this happens it may be hard to get into first gear but subsequet shifts are easier due to the fact the vehicle is moving. You probably have a hydraulic clutch system which is low on fluid or may have air in the system. Before shifting into first gear or reverse try pumping the clutch pedal 5 or 6 times then shifting, if it goes into gear easier after this then you probably have air in the system, it can be bled similar to bleeding brakes. If this doesnt work you might be low on fluid, or have a bad master or slave cylinder.
Breaks are not working
Check the master cylinder for fluid, refill, step on the pedal a few times and see where it is going. Bet it is comming from over the rear axel.
Code 1505
HIS IS FOR A 2.0 ENGINE SAME CODE DEFINITIONS APPLY FOR 2.7 ENGINE VALVE LOCATED ON TOP REAR OF RIGHT HEADP1505 = IDLE SIR CONTROLL CLOSING COIL-SIGNAL LOW FOR COIL #1 SHORTED TO POWER P1507= IDLE AIR CONTROLL CLOSING COIL SIGNAL LOW FOR COIL #2 SHORTED TO POWERPorsche 911 Parts
2002hyundaisatafe
Disconnect the negative battery terminal, jack car up and remove the small and big cables from the back of starter, next remove the bolts holding the starter, remove the starter, rev to install new one.
What does p0765 mean
The code is for a problem with the overdrive solenoid valve inside the transaxle. The valve would need to be tested and probably replaced if the fluid and filter are ok.
Not finding what you are looking for?