20 Most Recent 1995 Eagle Vision Questions & Answers

well the bottom line is: is there fuel flowing? I would find the closest joint/cpling to the throttle body, disconnect it and crank the engine. Is there fuel coming out?

hello, check the crank sensor

there is a limp mode but I doubt if that is the problem It indicates that the torque converter clutch servo/solenoid is faulty run the fault codes to confirm if that is it or a faulty TCM check wiring around the transmission

Possible vacuum leak, Throttle positioning sensor, idle speed solenoid, Other possibilities too. Don't let it do that for too long, severe engine damage can occur.

3 bolts underneath and about 6 bolts on top

if the head gasket is not blown did you have head checked to see if it was warped? This can happen very quickly when it is overheating. The fact that u have oil and coolant mixing means that coolant is entering either from the head or a cylinder is cracked letting coolant in

it is around the thermostat just a little plug type thing with 1 wire on it

timing has to be off , this car is nothing but problems get rid of it and get a honda or toyota

a overheated car will not start back up until cooled off

bad combination switch ,change it

it is under the dash on the left it has 3 prongs on it and it is bigger that the others (longer put your flashers on and listen for the sound

use channel locks and rip it out

burn it

Scrap it $300 bucks

no matter anyhow , I have never seen one bend valves anyhow

are you getting fuel to the fuel rail ,

why are you pulling this off , this is crazy get a new car to many problems

when you put it back together did you soak the lifters in oil for 24 hours or at all , this noise could be anything I would have to see it and hear it , this is hard to tell when not there

did you put the pump on straight of the pullly or if it has the fan on it is it sitting flat , this would cause this because it is not balancing right when spinning something is off balance