20 Most Recent 2001 Bentley Arnage Questions & Answers

I am sorry to say it like this.... but if you can afford a Bentley (or at least the owner of the Bentley can afford one), You can probably afford to take it to the Bentley dealer and have them replace it for you.

With no alarm on. Ignition full on but engine not running Hold Big button on remote for at least 4 seconds Quick off and Big button again for two seconds Ignition off Check synchronisation operation.

As steering leaks are normally obvious at full lock, I am assuming your question concerns fluid going missing with no obvious reason? A ruptured suspension sphere diaphragm would be a likely way to loose fluid without pools forming on the floor as the hydraulic reservoir feeds more than the steering.

The right hand battery supplies the engine cranking current and so is of a type that has a high cranking performance. This has an effect on the amp/hr performance. The left hand battery is of the deep draw kind able to supply a low current for a long time. Both batteries are only connected to each other and charging when the ignition is on. Manual charging would be one side at a time. If the left has gone flat switch on the ignition for a while before trying to crank. The car works fine with the same batteries in but not Bentley fine.

The Arnage uses a 4-20 loop sensor. It is positioned as previously described but is not easy to get to. Unlike an oil switch it costs around 450 GBP . Part number is 07V965515

usually done from under the hood, a plug goes into the headlamp which holds the bulb itself, take that out and replace the bulb.

Oftentimes the check engine light will come on with no adverse effects. the computer may have detected an intermittent problem. The light may go off on it's own it a few days. I would recommend "scanning" the system and retreve the trouble code and determine what is really wrong.

Sounds like the oil cooler for the hydraulic suspension,and steering.I had the same problem with mine.I took out the oil cooler...found the leak,and braized it.There are onlt 4 bolts,and 2 hose clamps to remove it.

Have you checked the low and high pressure switches ?