20 Most Recent 2003 Chrysler Town & Country - Page 8 Questions & Answers

? are you sure no one pushed the Button on teh dash that activates the Hazard lights? Also do you happen to have dual Power sliding doors? I have a Chrysler T&C and my hazard lights are set to activate when either side power sliding door is activated, if you lights are activated when the doors and not in operation and no one has bumped the hazard button on the dash then only other thing I can think is that the relay that activates the lights is in Dysfunction mode. Hope this helsp somehow.

Follow the top radiator hose to where it connects to the engine. That is where the thermostat is.

Down by the bottom of the radiator. pass side. on the frame/rad support. You probly have to remove front splash shield to get to it. I have never had to remove or change one.

Do you have power and ground at the blower motor ?

loose flexplate bolts would make noise all the time,wat u got sounds like a rattling catalytic convertor,meaning a worn out cat or cats. u can get under neath an hit on the exhaust pipe near the cats with engine off an hear the rattle ur talkin about. have u noticed a slight lack in power or performance ? another telltale sign of bad convertors. a local exhaust shop can raise car on lift an chek cats,inexpensive chek,expensive repair. good luck

Since cars were invented with heaters, most all of them take from 3 - 5 minutes or more to warm up enough to make heat for the heater. The colder the outside temperature, the longer it takes, usually. I remember in the mid 1950's a Buick I knew of had an electric heater in it. Never heard of one since. Be blessed.

the first thing I would be looking at is the flex plate that the torque converter is bolted to. It has the ring gear on the outside and are prone to cracking and braking off the crankshaft

need a new ign lock--junk yards have used ones but the key has a chip init and wont match--go to napa and xplain

check for vacuum hose failure . Cracked broken

faulty instrument panel

replace the sensor it will start working again

Better description than I could give: http://forum.chryslerminivan.net/showthread.php/6685-Code-P1698-and-Faulty-Instrument-Panel

Hopefully it's the switch behind the dash. I would try replacing your selector switch before messing with the blend door. You have to pull the dash out to access the blend door

I had the same problem on the driver's side.
bad motor - $280.00.
Typical Chrysler ****