20 Most Recent 2003 Chrysler Town & Country - Page 2 Questions & Answers

Is a starter any good?alternator.

This could be the axle shafts are loose and not seating in the transmission when the wheel is straight.

Better answer, check your fuses. Not sure about your specific vehicle but most fuse box's are either under the dash or open drivers door and check for a panel on side of dashboard (where dash meets door)

Check the air gaps on the abs ring to sensor.

tune up, replace air cleaner.

Basically the PCM seen voltage on a wire that wasn't supposed to have it. Usually the wire/s that run from the relays to the PCM. It could be that one of those wires shorted to positive. Also the fuse /relay panel can short on the inside.

CHRYSLER CROSSFIRE 2003 2008 WORKSHOP FACTORY SERVICE MANUAL for the easy solution download the pdf file

With the wipers in park (turned off) wiper arms loose on the transmission set to normal place they would be when off then tighten them down

2003 Chrysler to get your solution click this link

Could be a bad instrument panel(IP). Rough idle in gear could be a vacuum leak. Maybe a tune up.

https://en.wikipedia.org/wiki/Core_plug expensive if corroded. engine has to be taken out and corroded welsh or core plugs replaced. Had this repair done on my holden vn commodore recently. Water leaks at back of engine on sides.

Finding Automobile Repair Manuals Online http://www.ipl.org/div/farq/autorepairFARQ.html Chilton Repair Manuals http://www.chilton.cengage.com/ Factory Automanuals http://www.factoryautomanuals.com/ Haynes manuals Haynes Publishing http://www.haynes.com/ Autolit.com http://www.autolit.com/index.html RepairManual.com www.repairmanual.com Autoguide.net http://www.autoguide.net/partsandservices/advice.shtml Public Library http://www.mymcpl.org/blog-tags/auto%20repair http://www.mymcpl.org/online-information/research-databases/Aut omotive%20and%20Small%20Engines

Your headlamps are controlled by two different modules , BCM -body control module an integrated power module ! Your headlamp switch is a low voltage input to the BCM , after receiving a headlamp request the BCM sends a serial data message to the integrated power module , which then turns on the headlamps . You would need a factory scan tool to diagnose this to start . Your best bet would be to take it to a ASE certified repair shop !

These devices use motors with worm gears to provide the smooth operation and torque necessary to move the seat. The most common problem, other than the motors themselves failing (and since your does move somewhat, the motor is probably OK), the next biggest issue is something gets caught in the gear drive. Get a good look under the seat and see if there isn't something jamming the forward-backward motion of the seat.

Replace it, there is a cam, latch and spring that wear out.