2000 Honda Accord - Answered Questions & Fixed issues

What would you like to know before proceeding with this procedure???

need to check codes and see if it has oil in it. and go from here.
if the computer sences low oil pressure it sets a rev limiter to try and save the engine. code P1259 i think. 4 or 6 cyl?

Question edited for the dozens of typos and translated into written English. Question moved from MISC to model category. Reset the security system. You disconnected the battery with the 100 amp fuse. Really you need an auto electrician with a pro grade scan tool computer. There may be more to this than meets the eye.

no inertia switch check relays --module short possible burnt them out

Error code 12-01: Voltage for VBU (Voltage Back Up). - Check fuse fuse number 1 (70 Amp), in the under hood fuse/ relay box. - Check Wiring. - EPS Control Unit.

The owner's manual will show you what fuse is for the AC. You can find a manual here: Owner Manual 2000 Honda Accord Sedan Honda Owners Site It has one for the sedan and one for the coupe. For a video of how to change the fuse, go here: Interior Fuse Box Location 1998 2002 Honda Accord 2000 Honda Accord EX...

it sounds like your lock actuator inside the door is bad

When your vehicle is coming up for due maintenance, the light will flash for a few when you start the car. When the time for scheduled maintenance is due, the light will remain on constantly. It's just routine maintenance, but if you haven't done it, that's your reminder. Then, you or your mechanic will have to reset that maintenance reminder light.

Utube

Ignition packs, timing, fuel

http://www.speedwayautoparts.com/index35.htm follow link and click on torque tables and look up your vehicle, has most vehicles in their database

before you waste money on the mechanics word , take it to a professional auto transmission shop for a proper diagnosis and quote if only one gear has a problem , it indicates a possible clutch pack / band adjustment or solenoid /servo problem or even dirty oil

the system may just need recalibrating the usul way with electronic power steering is to start the engine the rotate the steering wheel full lock both way a few times to let the pas module to recalibrate itself try it it may work unless the reversed polarity has blown the module or sensors

Follow the given link, maybe you get something useful. 2000 Honda Accord Workshop Repair Service Manual PDF Download

could be a hose but it is costly always check the water and have it pressure tested fast driving with a leak can empty the sustem and burn the engine

Repair your vehicle right away. Just click on the link I attached https://www.reliable-store.com/products/2000-honda-accord-workshop-repair-service-manual-pdf-download

First check the connector and wiring. If good, remove the idle air control valve and clean the passages as well as the valve and seat. Reconnect the valve but don't install. Have someone start the car while you plug the downstream passage. The car sould idle down or stall, and the valve should retract. Remove your finger, and the valve should extend. If the car will not idle down with the passage plugged, you have a vacuum leak. If the valvedoes not react properly, check continuity of the wires to the ecu.

Try checking out the wiring and if not just buy new bulbs

On this website, you find fuse box diagram and description for Honda Accord (2001) Honda Accord 2001 fuse box diagram Auto Genius

take to the aircon shop for a quote...they will test and quote....