20 Most Recent 1993 Honda Prelude - Page 5 Questions & Answers


This is caused by a failed clutch slave or master hydraulic clutch release cylinder has, it is best if these are replaced as a pair. here are the parts u need.
BRUTE POWER / PERFECTION CLUTCH Part # 39836 Hydraulic Clutch Master cylinder
BRUTE POWER / PERFECTION CLUTCH Part # 3788 Hydraulic Clutch Slave Cylinder

1993 Honda... | Answered on Jul 30, 2010


I do not know for sure about the prelude but once you take the lug nuts off of most vehicles, the only thing holding the rotors on is the brake pads. Usually, you can remove a couple of bolts from the back of the calipers, maybe just one and the calipers swing on a hings away from the rotors. One swift kick to the rotor will usually free it up. Who needs a rubber mallet.

1993 Honda... | Answered on May 29, 2010


Change the coolant sensor

1993 Honda... | Answered on May 02, 2010


i hope this helps, well i tried to upload a pic for you but the file is to big so i will give u an address to just copy and paste.

http://spoon.org/civic/pics/Interior-Fuse-Panel.jpg



1993 Honda... | Answered on Apr 25, 2010


The fuel pump jump started? The fuel pump relay is in the dashboard relay center. The fuel pump is inside the fuel tank. The pumps do fail entirely nd the fuel pump should make some sound if it's running. The fuel filter is on the firewall on the drivers side. It has a bleeder screw in the top of the bnjo bolt that holds the fuel line onto the filter. Loosening this bolt should release fuel pressure. With the bolt loose try to get the pump running ( knock on the relay, fuel tank, while cranking the engine) if fuel flows the engine should run if you don't have other problems. Low battery will crank the engine but not turn on the fuel pump and or the injection system and even the ingtion system. It may still crank and sound OK. Voltmeter the battery with the engine cranking, Less that 10 volts it's unlikly to start. John

1993 Honda... | Answered on Apr 21, 2010


First try that new bulb in the other working side just to double check it. If it blinks then great. Second take a pocket knife or a toothbrush size wire brush and scrape the inside of the bulb housing so the bulb can get a better ground, Clean the conntact point that the end of the bulb sits on in the bottom of the housing too. Let me know if this does the trick, I can use all the thumbs up I can get. Raz

1993 Honda... | Answered on Apr 19, 2010


my car doesn't want start.

1993 Honda... | Answered on Mar 26, 2010


petrol engine ,alloy head ??about 70 lbs

1993 Honda... | Answered on Mar 15, 2010


Check fuel pressure.

1993 Honda... | Answered on Mar 09, 2010


Did you do a full tune up?
Do a compression test and check for any cyclinder that is low in PSI.
Look of wet plug and oil coated plug(s).
== Which item CO,NOx,Hc is failing?
You may need to repose to add information.
Use a plug non-fouler / protector on the weak cylinder will help if HC is just shy from the passing limit.
3dc4919.jpg

1993 Honda... | Answered on Mar 05, 2010


If I remember correctly, on the prelude it can be reached through the trunk. Lift the carpeting and/or mat to expose the access door.panel. Disconnect the negative side of the battery for safety purposes. Label the fuel lines with a piece of tape if you like. Disconnect them. Remove the nuts that hold the assembly in. It's usually best to put a mark on the pump and the tank, just in case you have any trouble aligning the new one in the tank. Carefully remove the pump assembly with a lifting and turning motion remembering what angle the pump faced. It's relatively quick and easy.

Kindly get back to me with a kind word if I've helped in any way.

1993 Honda... | Answered on Mar 03, 2010


you have got a bad earth. Remove dash the nagtive wire has a weak supply which is connected to your fuel gauge .Connect a wire from the dash nagtive and groud it to the body of the vehicle.

1993 Honda... | Answered on Feb 19, 2010


Change your air filter first.

1993 Honda... | Answered on Feb 18, 2010


this sounds like the cable has run inside the motor, and the clicking sound you can hear is the motor tuning on the cable, you will have to remove the door panel and the motor to either re run the cable if it is out of its fixing, or replace the motor as this is normally an all in one unit and has to be replaced as one inc the cable....hope this helps

1993 Honda... | Answered on Feb 15, 2010


The right lower control arm is more than likely bent. You really can't tell if bent although a person who is a qualified front end alignment specialist can tell you what is needed to repair

1993 Honda... | Answered on Feb 04, 2010


Most likely an air fault, check the airflow meter and air flow sensor, if it is not getting air then it will not start, keep pumping the gas if you can smell it after a while then its getting plenty of fuel.

regards

Dan

1993 Honda... | Answered on Feb 01, 2010

Not finding what you are looking for?
1993 Honda Prelude Logo

228 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Honda Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Prelude Honda

  • Prelude Honda

Most Popular Question

93 honda prelude vtec h22a1 block having

  • Cars & Trucks
Loading...