20 Most Recent
2000 Honda Prelude - Page 3 Questions & Answers
Crankshaft pulley
Tighten to spec (very tight...) and with the right tools. Or just get a new one. Something could be faulty with the one you have.
Front Noise!
I have a 2000 Honda Prelude SH with about 110k on it. I have been having all sorts of squeaks from the suspension over the past 1 or 2 years. It was the front ball joints that were found to be causing the noise. I also had an upper control arm and a tie rod end that was squeaking. The reason for the squeak is the sealed design of the ball joints and the fact that they cannot be lubed, and eventually just wear out. I could get it to make the noise by pushing the car up and down at the affected corner. I've been disappointed in the way the suspension on this Prelude hasn't really held up well. I've never had so many suspension components wear out on any of my cars before. But, your issue definitely sounds like ball joints to me. Those are the same symptoms I was having.
Honda prelude has no signal
check igtion fuses and relays if that doesnt work take one neg battery cable off for 2 min so the computer resets
Oil leaking out from hood
The people who worked on my car in January left the cap off.....luckily I called Triple A and they found it...there was no more oil and it is lucky I stopped driving the car, as it could have been disastrous.....bought a new cap and 4 qts of oil and all is well.
Radio code for honda prelude
The code should be on top of your radio, the only thing you got to do is remove the plastic that goes around the AC controls and stereo. You can either unscrew the radio it self or the AC controls. I have done this a few times just because I misplace the code and of course I have to remove the battery cable to perform certain jobs.
I have a honda prelude
Hi
So the new fuse blows up straight away?
you cant check the wire like you are doing.
Check with multi meter for continuity. then you will find the problem.
You can put slight bigger fuse and see if that solve the problem.
Using my OBD II on 2000 honda prelude trouble
I would start with whatever is causing the misfire. That seems to be the core of your emissions codes. Putting all codes together it seems to be clogged injectors vacuum leak. Seems to be causing stalling too.
How does one remove broken
if it has air bag in the wheel first you have to isolate the switch
from the back of the wheel spokes ( side facing dash) there may be 2 screws set well into the spoke that are undone to get the center of the wheel out first
from there on it is the same procedure as removing any steering wheel
all is explained in the workshop manual
1994 Honda Prelude si starting problems
Your starter motor is either not getting power or in need of replacement. Otherwise, there is nothing wrong with your car.
Also check your battery connections for no corrosion there as well as by the starter motor. Low voltage circuits in a car are extremely vulnerable to poor contact issues.
Not finding what you are looking for?