20 Most Recent 2000 Honda Odyssey - Page 7 Questions & Answers

fuel rail on top of engine

hi ur problem is a cylinoid the transmission have up to 6 speed I replaced my Honda odessy I put the fouth one it was driving and then wouldn't drive u have to change the number 1 cyliniod

the solution to the sliding door problem is simple the doors have small rubber rollers they have to be changed every couple of years if u do one side u should do both sides they are inside the door panels

double posted, please dont. go back one post. its there.

RULE 1: ALL EFI cars about 1988 to now , there is no ECU that ever tells you what parts failed, (its not a AI genius puters...)it can only tell you, what tests failed (called monitors) that directsthe technician to do more manual tests, this is all covered in the FSM. read it.the cat tests? ignore this, if not a smog test town? (no country stated)but if you fix all other issues, usually the cats tests pass, fix it lastif at all. end cat eff. comments. (or as your laws direct)keep the faith, 498reset the OBD2 codes, then tighten the gas cap (seal good?)then drive 20miles, its ok now right.? 99% factor loose cap...if above fails (good cap test) (a new cap can fix it too, bad vacuum breaker leaking or seal)easy path gone......................................you need to do all the EVAP tests in the FSM.the first it the leak down test. (tools needed.)you can make your own tools to do that, i use lowpressure regulator connected to a nitrogen tank and modified gas capand a low pressue guage. if it dont hold say 2 psi? for 5min)then the system is breached, and you get to find it.but every word here and 100s more on topic are in the FSMread it, and do the tests stated there, if not get an ASE mech.he/she can do it. easy.EPA here, just hates, EVAP fails.. top cause of pollution today.here is USA< nobody ever posts location (seen 1 in 4000)

no engine stated? wow. 3.5L? says no gap settings.its in the FSM. many cars dont put it in the op guide as the plugsare rated to 80k miles or more, and is not consider, operator deal.sadly.and many folks think the new plugs are set in the factory , WRONG. (comment is for J plugs not surface fire tech)i see you are there.!many stores, list it wrongly too.... vast....but you never said country car was sold. in the USA we open the hood, look up and behold, its right there.the vacuum and turn up sticker, now alldata.comquotes to follow.........all.the original equipment spark plugs installed in the Odyssey 3.5L V-6 engine are platinum tip spark plugs, and the plug gap must not be adjusted.and other warnings, and the no file them warn.gOn CR-V and 4-cylinder Odyssey models, adjust the spark plug gap to 0.039-0.043 inches (1.0-1.1mm). On Odysseys with the V6 engine, check, but do not adjust the spark plug gap. The spark plug gap should be 0.039-0.043 inches (1.0-1.1mm). If the spark plug gap exceeds 0.051inches (1.3mm), replace the spark plug.so 1mm , if not v6

??????????????????????????????????????Problem with 2000 Honda Odyssey Sec air system n/a for my 2003 ford crown victoria

Not likely. The rear unit isn't high enough.

For 1999 Honda Truck Odyssey 3.5L MFI SOHC VTEC 6cyl the Fuel Filter is located under hood, driver side, rear side of strut tower, mounted in corner.



Fig. 1: The outlet line on a firewall-mounted fuel filter uses a banjo bolt type fitting- CRV and 4-cylinder Odyssey models

Hope helps (remember rated this).

Check for Fault Codes & Cylinder MisfiresYou know the Belt Replacement is not related

clean the ribbon cable or connector with contacts cleaner, from dirty , corrosion, and tight very well again. However the dashboar the IC inside can be faulty, if the problem persist, to due age.see the diagram attachedGod bless you

It's your rotors. Also called Brake Discs. You have 2 choices, take them off and have them turned/refinished or replace them. I would check the cost of simply replacing them first, its usually the way to go. You do them in pairs and you need to replace or refinish your front brake discs. All the best.