20 Most Recent 2000 Honda Odyssey - Page 5 Questions & Answers

First: check the transmision fluid level; the owners manual explains how to do it. If it is not up to the correct level, use only the product specified by Honda. Second: If the above does not solve your problem, its time to get a new transmission, or junk the vehicle.

Spray dry teflon lube in the key hole and then use the key to work it in the lock. You don't mention if the key turns at all or i you tried the passenger side?

SRS steering restraint system this is part of the air bag it either detected a fault or the seat belt are not on and has detected weight on the seat like bags purse and it thinks it someone.the air bag wont deploy if the seat belt is not on. another cause is a service check this comes on a a certain mileage that a scan tool can read that can do air bag.

Id suggest taking it to a mechanic. there are so many things that could be wrong on todays vehicles. good-day! but did you check the spark plugs, or maybe fuel filter needs changed, (not getting enough fuel under load.) Good-day!

Honda calls them Top Dead Center sensors and there are 2 of them. The connector is shown in the picture. Follow the wires to the sensor.

Try cleaning the map sensor and the mass air flow sensor. Do not use carb cleaner. Use cleaning spray that is safe for MAP and MAS sensors.

not sure but check between gearbox an engine. Where the flywheel is

Hola Me LLama Pedro, Etsa circa de compartemento, Aqui...

Hot out? Check your coil.

It is located at the front of the right transmission cover

Type: Honda OBD P1457 Then read about the issue

Most likely its your warm/cold air door motor that is stuck in the cold position. This is in your duct work under the dash. Less likely would be a clogged heater core, needing to be flushed. And even less likely than that would be your dash temp control switch.

Rate my answer with the thumbs..........Thanks

Apply new engine oil to the threads and flanges of the cylinder head bolts. Tighten the cylinder head bolts sequentially in three steps. NOTE: Perform each step twice. 1st step torque: 39 Nm (4.0 kgf-m, 29 ft. lbs.) 2nd step torque: 69 Nm (7.0 kgf-m, 51 ft. lbs.) 3rd step torque: 98.1 Nm (10.0 kgf-m, 72.3 ft. lbs.)

3/8" square indented plug on side of trans near bottom, use a ratchet without a socket to take It out. Be sure to fill with honda genuine fluid only, some cars you can use aftermarket fluids, but it don't recommend it on Hondas.

Sounds like a possible air lock. Trying running the vehicle without the rad cap until the rad fans turn on allowing the cooling system to burp out any air. Good luck.