20 Most Recent 2000 Cadillac Escalade - Page 6 Questions & Answers

http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?pageId=0996b43f80370970 Here's a guide on how to bleed system.

keep reservoir topped up and lockwheels left and right should take fluid down and and clear air from pipe

whats it doing or better still not doing

I would check the spark plugs to see if they are fuel fouled.

There are items called "shoes" or the plates that shift vehicles. Reverse and first are commonly used to gether in most vehicle. The trasmission shifting shoes need diagnosed.

remove the driveshaft then romove the yoke and the seal there may or may not be a clip holding in the bearing but when changing the bearing the race should be changed for this remove the wheels with the diff on stands remove the rear cover on the diff push the axles in and remove the c-clips from inside the diff then pull the axles out inside the diff you will see 4 bolts remove them and take out the spider gears and drive gear once the drive gear is out you can use a punch and hammer to remove the rase to insall the new rase use a BRASS punch as to not damage the new one then install parts as they came out

I would take a look at the water pump. There is a weep hole on the water pump to indicate if the seals are going bad inside the water pump. This hole is located on the top of the water pump where the pulley mounts to it. If this is not the problem, then it could be a number of other problems.I would check the following items, which I have listed in sequence of cost to repair.1. check hoses and clamps, if leaking you should see areas that have build up of dried antifreeze.2. check thermostat housing on top of intake where upper radiator hose connects to engine.3. verify radiator is not leaking4. intake gasket leaking5. head gasket leaking

see the diagram attached and proceed to fix if:GOD bless you

the timing may be off. It needs tobe calibrated.