Top 20
1987 Honda Prelude - Page 8 Questions & Answers
I want to replace the
The procedure to replace the tail light is as follows:---
1) Open the trunk.
2) Push
the trunk fasteners in until it pops using a flathead screwdriver to remove the
lining and access the bulb sockets.
3) Remove the frame away from trunk and you will see the light bulb assembly.
4)Twist the bulb out of the assembly towards counter clock wise direction.It will come out.
5)To remove whole tail light assembly.Its connected with screws.Remove those screws and disconnect the wiring connector from its side and lift the tail light assembly out.
6)But if you want to only replace the bulb then no need to remove whole tail light assembly out.Just remove bulb and replace new bulb in reverse and install all parts in reverse.
--------------
This should help.Thanks.Helpmech.
I just washed the out
For a car to run it must have ignition, fuel and air (for combustion). each of these can be checked easily:
1) If you have a rubber glove or plastic bad, take off the to the distributor (from the coil) and hold it with the glove or plastic material about 1/4 inch from a piece of clear metal on the car body or engine (a bolt works). If it sparks the ignition is ok when you have someone crank over the engine.
2) take the top of the air cleaner off to see if you can confirm gasoline is being pumped when someone cranks the engine. Or, get some starter fluid and spray it into the air cleaner when it is cranked over by someone. If it starts and dies again it is either your fuel pump or it is out of gas. If the air cleaner is dirty try the above without it (replace if dirty).
If the above does not work it needs to be checked by a mechanic.
Oil leak at the base
Try tightening the filter a little bit but over tighten it.If it still leaks then replace the filter because the seal on the filter is leaking.
Windows keep fogging up can
If they fog up when you turn the heater on, you could have a leaking heater core. You should also be able to detect the smell of antifreeze.
1998 Honda Prelude - Hard
Hi and welcome to FixYa!
Try to have an oil change. The present motor oil inside the engine can be a little sludgy and an oil change can resolve this.
Hope this helps and thank you for using FixYa! Have a good one!
QUI PEU M'AIDE JAI UN
Hi, please interpret you question in English so as to enable me read, understand and proffer a solution.....
ENGINE LIGHT COMES ON
Does it stay on??? All engine lights come on when you start the car...then go off. You need to give a bit more info.
I just bought a 93
not really. The engine uses hydraulic lash adjusters, so there is nothing for him to adjust. If the engine has been run at all, the valves should be seated. If not, maybe the guides were over-knurled. Can't really tell why they are clicking. Can he provide specifics of what was done to the engine? Does it have new lash adjusters? Were the guides knurled or what was done with the guides? What was done to the valves? Are the springs new? Are the camshafts new? etc. etc.
1989 Honda prelude speedo doesn't
sounds likle you have eithor vehicle speed sensor not working or the cable behind the dash is not connected or loose check the speed sensor it is on the transmission outside the tranny maybe it has come loose or is broken worn out hope this helps
Not finding what you are looking for?