20 Most Recent
2004 Cadillac Deville - Page 7 Questions & Answers
Heat don't work
check coolant level. is it low? refill and remove air from system.
check for codes in IPM
Can't put key in the ignition
try moving your steering wheel back and forth while trying key. I don't see how you could move the steering column, its usually bolted in very tight. If you can move your steering column, it needs tightened up immediatly!
Drivers window
does the motor make noise when pressing the window button? Your cable that brings the window up and down may have snapped. Open the door and take off the interior trip. See if there is a steel cable hanging around. Replace as need. Note it is better to buy the WHOLE assembly with the steel cable and the motor.
How do I replace a
Replacing the license plate bulbs was simple. It took all of 20 minutes. Don't let the directions fool you. Remove the lift gate screw.Use a 10mm deep socket to remove the 5 nuts.(you can see the nuts on long bolts).Get a screw driver and gently pry the panel up. You can see everything right in front of you. Easy job if you have ANY kind of common sense.
I replace the evaporative system but the code do not reset
The code was po440? po456? these codes must be tested and passed by the cars computer system before it passes the evap monitor. testing criteria fuel tank must between 15% and 85% and must be sitting 8 hours minimum when key is turned on outside air temp and engine coolant temp must be within 10 degrees of each other. start engine let idle for 3-5 minutes take for a short drive 3- 5 miles lets sit then try it again this could take up to 3 days. With a factory scanner you can perform a evap bay test this is a forced test to see if a repair will the true test.if fails it will set a soft code for a repair then retest evap bay test again. Also factory scanner can tell you if a code has been test since codes cleared and if run this ignition cycle.and test results.
How do I replace a headlight
depending on which side open hood behind lights theres 2 clips with tounges on them pull both up the lenses should come out to put back reverse of proceedure
Heater core
located in the dash behind the fire wall. you have to take apart dash to replace
Not finding what you are looking for?