20 Most Recent
1997 Audi A8 Questions & Answers
Limp mode audi a8
Need to have it scanned by someone,the parts houses such as autozone usually will do this for free. Notate the code number that this gives,it may be as simple as an external sensor or loose wire to transmission.By the way you can google that code number and get lots of usefull info
8/22/2014 1:00:03 AM •
1997 Audi A8
•
Answered
on Aug 22, 2014
Battery Dead, can't get into trunk to jumpstart
remove the bottom cover below the engine and connect a battery charger or jump box to the big red wire on the alternator. Ground to the alternator case or engine block.
Wait about 5 minutes - and try to pop the trunk. Then charge the battery as normal.
Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.
4/17/2013 7:03:58 PM •
1997 Audi A8
•
Answered
on Apr 17, 2013
My audi a8 auto box 97 model lose power can you help
start with the easy way , try to use a good fuel injectour if it did not work change your fuel filter , , i need more details in how dose it lose power ? is it when you speed the car jerk , ?? did you scan it ? and did you check if you exhuast blocked ??
3/26/2013 9:17:00 AM •
1997 Audi A8
•
Answered
on Mar 26, 2013
No power to pump no fire
Check the fuel pump fuse first. It would be No 28 if I'm not mistaken. If OK check fuel pump relay.
9/13/2012 11:32:18 AM •
1997 Audi A8
•
Answered
on Sep 13, 2012
Water coming out of rear seat vents
The problem is that the drains of the motor compartments are plugged up => the water gets into the airco ducts, which have drains in the passengers compartment and are also plugged up... If you leave the air on circulating, the water problem is not there as no water comes in, better is to unclog the drains, there is a description on how to do that, if you need it mail me at rfaass at yahoo dot com and I'll send you a pdf. If you need further help, I’m available over the phone at
https://www.6ya.com/expert/robert_573a00ba7e399076
12/5/2011 3:25:42 AM •
1997 Audi A8
•
Answered
on Dec 05, 2011
How do you reset a 1999 Audi radio code Read
IMPORTANT NOTE: You must have the security anti-theft code for your Audi radio from the car manufacturer, or from an Audi dealer!
The sequence of programming for Audi radio is:
1. Push simultaneous "SCAN" and "RDS" keys until on the screen will appear "1000" displayed.
2. Release keys. No more push on "SCAN" and "RDS" keys because otherwise number "1000" will be considered as first safe code attempt.
3. By the #1 key you will set up the first safe code digit.
4. By the #2 key you will set up the second safe code digit.
5. By the #3 key you will set up the third safe code digit.
6. By the #4 key you will set up the four-th safe code digit.
7. Then push again simultaneous "SCAN" and "RDS" keys for confirm this safe code. On the screen will be displayed "SAFE" notice. Release keys! For few seconds a radio frequence will be displayed. The radio is now ready for use!
Please do rate my response. Thanks!
5/31/2011 1:17:00 PM •
1997 Audi A8
•
Answered
on May 31, 2011
Not finding what you are looking for?