20 Most Recent 1994 Plymouth Colt Questions & Answers

Transmission fluid has a red dip stick near the transmission red in color. It can only be checked while the car is on and warmed up.. that is also where you fill it. If you need further help, reach me via phone at https://www.6ya.com/expert/chris_b82b45c59bcf133d

add some gas line anti freeze to the tank to absorb the water . that sounds like the problem , but you have no way of knowing how much water you got

ok
if it just sticks without any strange sound or lack in power then you just need a new pedal wire or a master cylinder of the clutch pedal i don`t know that kind of cars but its old and probably will using just typical wire just review the fluid reservoir of the clutch master for any lack of fluid or sweating

LOOK FOR A PLUG ON THE SIDE OF TRANSAXLE CASE.LUBRICANT SHOULD BE CHECKED WITH COLD ENGINE AND LEVEL VECHICLE.RAISE VECHICLE SUPPORT WITH JACK STANDS.MAKE SURE VECHICLE IS LEVEL.WHEN YOU FIND AND REMOVE PLUG.IF OIL POUR OUT HOLE YOU HAVE ENOUGH IN GEAR BOX.IF NO OIL COMES OUT.INSERT YOUR FINGER TO FEEL THE LUBRICANT IT SHOULD BE 3/16 INCH FROM THE BOTTOM OF PLUG HOLE..IF NOT ADD OIL USING A FUNNEL WITH A RUBBER HOSE OR SYRINGE.BECAREFUL WORKING UNDER VECHICLE.MAKE SURE YOU ARE ON HARD SOLID GROUND CAR IS LEVEL.MAKE SURE TO USE JACK STANDS.MAKE SURE CAR IS SAFE AND SECURE NOT MOVING IF YOU SHAKE IT.

It should be on the engine block close to the oil filter. It will have one wire plugged into it. Use Teflon past on the threads of the new unit and do not over tighten.

Inside the car at the inlet to the evaporator core.

Tires may need to be rebalanced.

it usually between the radiator & the grill under the hood.......cheers

ODDS ARE IT IS AN INTERFERANCE ENGINE FIRST BAR THE ENGINE OVER WITH
A POWERBAR IF IT LOCKS UP THERE IS ENGINE DAMAGED (valves or piston)

power to the blinker is fine so a ground to the bulbs are at fault

Between the head and cylinder block . The intake comes off first then valve cover , camshaft , loosen head bolts , disconnect exaust or unbolt exaust manifolod and the head will seperate from the block. The gasket is at that seperation point.