20 Most Recent
1991 Plymouth Sundance - Page 9 Questions & Answers
1996 Plymouth Voyager heater valve location ?
If there is no heater control valve visable on heater hoses ,then it does not require one. heater core could be stopped up. flush the inlet and outlet with a water hose,and bleed coolant system.
1990 plymouth grand voyager, acts like a bad alternator but replaced 3 times, replaced control module once. still drains battery.
What is battery voltage with engine running? How long does it take to drain enough to prevent starting?
A 1990 Plymouth will likely not have parasitic power requirements. With ignition in off position the battery current should be zero (0.00 amps).
So using a current probe or shunt, with ignition switch in the off position, systematically remove fuses to identify the circuit draining the battery. Likely you'll find some after market add on (radio etc.) that is not installed properly.
Comment here with results and someone will assist further.
1981 Plymouth Reliant starts right up...Idles great....Give it gas back fries through the carb....even when driving down the road...After the back fire starts to idle rough....
There are many reasons why an engine should spit back through the carb. I once encountered a Ford that had a worn exhaust lobe on the camshaft so the valve was barely opening - the engine ran very well until the throttle was opened. It is still a huge mystery how the owner had managed to drive it to my workshop.
The most common reason is a lean air/fuel mixture caused by one or more carb jets being blocked.
A thorough carb clean is a sizeable task that shouldn't be undertaken lightly and it is best practice to tackle it last after ensuring everything else is as the manufacturer intended it to be - from spark plugs and spark power/quality, timing, valve operation, fuel delivery quantity and pressure, etc., etc.
I can't get the left outer tie rod end to screw off why?
Oxygen and Acetylene is ideal but MAP GAS or Propane can be used. They just take longer to get red. Getting the part hot will expand the metal but turning the threaded area red will dissolve rust build up. Don't try to spin the part immediately. With two pairs of large pipe wrenches or two large vice grips. Rock the threads back and forth repeatedly. 6-8x will usually work the rust away and allow the tie rod to be spun off. Cranking and turning the tie rod in one direction sometimes causes the rust to build up and seize the threads again. Because of tolerances you may need to wait for the part to cool down before the threads will start to move. Hope this helps. Good Luck.
1997 Plymouth Voyager left blinker, radio ,blower 4 air conditioner not working
You should have fuses for them and probably relay for blower . Check fuses, relay and check for power to your equipment. Check the bulb, power to and ground at the bulb. Check fuse to radio and power to radio. Check blower relay and fuse if it has one and power at blower. Did all this go out at the same time. If they did was some work going on which could have created wiring or short in wiring issues. The link below is for a 98 but some of it may be the same. If you have question about which fuse check them all but if you pull them out do one at a time. Try running the blower motor in all setting, sometimes the resistor will go out and the blower may only work in the highest setting.
https://www.cargurus.com/Cars/Discussion-t16702_ds678813
Not finding what you are looking for?